Make sure the front-panel speaker selector (on front of amp) is set to "A". Connect the left speaker to "A" left speaker terminals on back of amp (Red wire usually means "+" and Black means "-"). Do the same for the Right speaker using "A" Right speaker terminals on back of amp. If this doesn’t work, read the manual.
Connecting Klipsch Cornwall to Rotel RA-1062
I recently purchased a system.
Luxman SQ-N150 Amp
Luxman DA-250
Klipsch Cornwall IV
Bi-Amp speaker cables ( these were recommended but I am new to bi-amping/bi-wiring)
The amp is on back order so I am using my single Rotel RA1062 until it arrives. If I connect both speakers to A or both to B only one will have sound. A-Left and B-right. If I connect one speaker to A and one speaker to B I get sound but imaging is terrible. Does the bi-amp cable cause the need to use both A and B? I saw on another thread that the poles are reversed when bi-amping. I will try to switch that (assuming A and B are in effect two amps).
Thanks,
Bill
Luxman SQ-N150 Amp
Luxman DA-250
Klipsch Cornwall IV
Bi-Amp speaker cables ( these were recommended but I am new to bi-amping/bi-wiring)
The amp is on back order so I am using my single Rotel RA1062 until it arrives. If I connect both speakers to A or both to B only one will have sound. A-Left and B-right. If I connect one speaker to A and one speaker to B I get sound but imaging is terrible. Does the bi-amp cable cause the need to use both A and B? I saw on another thread that the poles are reversed when bi-amping. I will try to switch that (assuming A and B are in effect two amps).
Thanks,
Bill
- ...
- 8 posts total
- 8 posts total