2. cables
  3. 151407-134953

How to A/B Test Power Cables & Interconnects?

Looking for some advice. Here is the situation:

  • I am building out a new system (dCS Bartok > Parasound JC 2 BP > Parasound JC 5 > Floorstanding Speakers)
  • Equipment is on-hand. I am in the process of re-wiring the A/C circuit with two matching, 10awg home-runs (one for power Amp, one for sources)
  • I have the opportunity to try some high-end power cables and interconnects
  • I will invest in the cables if there is a discernible difference. I am somewhat skeptical.
  • I am trying to come up with a test protocol to determine what these higher end cables do. Everyone advises that I do A/B testing will listening to music. Of course I will do this.


My question:

Is there some more objective way to A/B test power cords and interconnects? I prefer to do this by listening,...not using lab equipment. How can I A/B measure system "blackness" or noise level?


Any advice appreciated. Thanks in advance.


128x128temporal_dissident
clearthink
1,421 posts
 
millercarbon"First, you don't need lines for power and source. Not only is this a waste of time and money, you run the risk of introducing ground loop hum and/or DC offset causing transformer noise."

This is false and misleading for one thing it should be immediately obviously, clear, and apparent that using dedicated AC cannot possibly introduce, cause, or create DC offset in a component that is an absurd assertion, belief, and opinion as for dedicated lines if properly designed, installed, and implemented that will not cause an ground loop and in fact can prevent them.
Post removed 
temporal_dissident's avatar
temporal_dissident OP
13 posts
 
I was really hoping the first two responses to my question would be both impassioned and contradictory!  Thanks guys!
photon46
1,076 posts
 
If one wants guaranteed impassioned and contradictory responses, all one has to do is to start another topic about cables!
twoleftears's avatar
twoleftears
5,313 posts
 
Auditory memory is not long.  Still, best to play one cable/component for a while, to get thoroughly attuned to it, and then swop in B.  Be SURE that the last track you played with A is the first track you play with B. Best chance of putting your finger on what you hear different. Thereafter, let B settle a bit, and check your emotional responses.  Do you feel pretty much the same listening to both, or more involved with one over the other.
More to discover