Best step-up between a Kondo M7 and a Lyra Skala


Hello 

I have been using a vintage step-up (UTC A11)  between my preamp Kondo M7 and my cartridge Lyra Skala. The match was really good.

However, I had to give the UTC step-up back to my friend, and I am contemplating another option.

Do someone experienced a Lyra skala with a Kondo KSL-SFz stepup ? or maybe a KSL-CFz (menaing in copper nor in silver)

Or any other combination that match well (the UTC transfo are not easy to get in Europe ...!)

Thanks for sharing your experince

stelma
stelma
I have been using a vintage step-up (UTC A11) between my preamp Kondo M7 and my cartridge Lyra Skala. The match was really good.
Or any other combination that match well (the UTC transfo are not easy to get in Europe ...!)
How was the the A11 wired? The A11 supports 50Ohm, 200Ohm and 500Ohm primary impedance, so to make a useful recommendation it would be necessary to know which of these you were listening to and found to be such a good match.

The Skala has an internal impedance of 5.5Ohm, so I would assume it was either the 50Ohm or 200Ohm taps, but that’s no substitute for knowing for sure.

The Verion/Cotter transformer is likely a very good one, but there are scores of excellent SUTs available and only one with specs matching the one heard by the OP will sound (more or less) the same. Just throwing out names of good units isn’t really that helpful in relation to the actual question.
""The Skala has an internal impedance of 5.5Ohm, so I would assume it was either the 50Ohm or 200Ohm taps, but that’s no substitute for knowing for sure. ""

Yes, it was 50 Ohm and the match sounds good ... 

Indeed, I can purchase a Verion/Cotter .. but does some tested it with a Skala and a M7 ? 

And I would really like to know if someone has try the Kondo KSL stetup with the Skala ? 

regards and thanks for your comments and input 
You should look into an Intact Audio SUT which is also marketed under the EMIA name.  Each one is custom wound by Dave Slagle to the specs of a given cartridge and is available with either copper or silver windings.  I use a copper 1:10 with my Benz LP.
Finally, I decided to invest in the Kondo KSL SFz ...
PLease wait some coiuple of weeks ... and I will update you to confirm (or not) this fit well.

Thank you ALL for your contribution and ideas ...
I have have had several iterations of the Kondo KSL - SFz  as well as the Audtorium T1 in my system.  i switched to the SA Lab about a year ago and prefer it to both the Kondo SFz and Autitorium T1.   I know several people that switched from the Kondo to the S.A. Labs once heard.

Kwame