2. cables
  3. 128414-84541

Please assure me I'm not going to burn my house down.

I recently bought some new mono class D amps to replace a stereo class D. I had a pair of identical diy power cords connected to the stereo amp and my preamp.

Well, with monos I was obviously going to use the identical power cords. So I needed a new PC for my pre, as the older diy version I had laying around just used thhn wire from Lowe’s and didn’t sound great. So, after some thought and research, I decided to make a PC out of cat 5 plenum cable. I kept it in its blue sleeve (containing 4 twisted pairs) and then I braided 3 lengths together for each conductor. I then took those three braids and braided them. What I have sounds incredible and I’m fairly confident that it is safe electrically.

Please reassure me. Or tell me I forgot about x, and that I should cease and desist. Or laugh at how cheap I am...

But really, I’m not going to start a fire here, am I? 8 conductors per length x 3 lengths for each conductor equals 24 strands of 24awg. Which equals 10awg for each conductor...
128x128toddverrone
ericsch
751 posts
 
As a retired insurance manager, I can tell you that only intentionally set fires are denied, i.e. arson. There is no exclusion for stupidity. For example, you leave a frying pan unattended on the burner, house catches fire, covered loss.

terry9
2,251 posts
 
To address your point about 24 x 0.6 ~ 15 (amps), and braiding together,  the current carrying capacity of multiples depends on their exact physical relationship. That is, if insulated wires are close together, they will not be able to radiate heat as efficiently as if they were separated. Then wires might get hot. Hot (copper) conductors have higher resistance. This has the potential to create a positive feedback loop, and we are back to the potential for HF.

joeylawn36111
574 posts
 
How much current does each monoblock pull? (on the rear of the amp somewhere it will say "120V xxxW" W being the power in watts the power supply pulls at maximum draw, not the rated speaker power output.) Then divide watts by 120 to get the current draw.

Also, there's the fuse rating of each monoblock. Let's say it's 8 Amps. Then you can use wire that's rated slightly higher than that, say 10 Amps. 14-Gauge wire is rated at 15A, so this would be about the minimum gauge for this example.

I can't guarantee that you won't have problems with your homemade PC, but if your wire is well-terminated (won't come loose/disconnected), and doesn't run hot, I don't see a problem with it. But if it gets moved around much/bent, some of the small wires of the CAT cable could break, which would put more heat strain on the remaining wires because they're still connected, and the same current has to go through less wires.

Like was said above, the ideal thing is to get some proper power cord to be sure.
Post removed 
toddverrone's avatar
toddverrone OP
840 posts
 
So far, they run completely cool..
@pbnaudio those (home depot) are the very cords I used when I first made my own cords a year and a half ago. All the other cords I've made since then have sounded better. But your signalcables link got me curious, so I may buy one, just to compare. 
@steakster @joeylawn36111 I'll check those specs later. Good point about twisted pairs not being able to radiate heat as well as an individual strands. Still, I've played the stereo loudly and none of my diy PCs run even remotely warm. Including the cat 5 one.
@ericsch thanks for the clarification. I guess if insurance companies could get out of paying claims due to stupidity, they probably wouldn't pay many claims at all..
More to discover