2. speakers
  3. 123921-1529

Adding sub to Sonus Faver Guarneri Evolutions...need advice where to set crossover on sub

As the title say, I recently pulled the trigger on a Rel T/5i sub to pair with my Sonus Faber Guarneri Evolution monitors. Ultimately when funds allow again I will add another sub. For now, I only have 1.  I have a small room that is 9x10x9 with the back wall only being 3’ tall, above that the room opens up to my family room and kitchen. I listen at fairly low volumes, no more than 75dbs typically. The Evolution speakers start to roll off at 72hz and its -6db point is 43hz. Its -3db point is around 60hz. Any advice on where set the crossover on the Rel would be appreciated.
128x128tboooe
miner42
709 posts
 
I followed the setup procedure outlined by REL.  My B1 integrates well with my Auditor Ms.  My phasing is at 0. 
daveyf's avatar
daveyf
2,836 posts
 
Your OP question is very difficult to answer. I would suggest bringing in the sub at about 50Hz. This is where the SF's tend to get a little weak. However, the room plays such a large part, that experimentation ( and lots of it) is the word of the day, IMHO.
tboooe's avatar
tboooe OP
1,009 posts
 
I have since repositioned by speakers and get my sub dialed in (I think).  In my room, I was actually getting good, flat sub response from 50hz - 40hz.  Once I spent some time moving my speakers around I get +- 2db response from 100-20hz, with a +4db hump at 40hz.  The mid bass and bass in my room is very tight and punchy.  Perhaps my hearing is not good enough, but I didnt find integrating my sub that difficult but I have never had "golden ears".
More to discover