2. cables
  3. 1402929426

Why Oh Why...another

I was swapping things around, and now have a humm. Before, there was no humm. When the amp is plugged into the speakers and my IC's not connected to it, there is no humm. When I connect even one IC to the amp, I get a humm, even if the IC is not connected to anything else on the other end. If I put my finger on the unconnected end of the IC, the humm sound get a little louder.

What's up?
128x128mikeba316
3 responses Add your response
zd542
5,339 posts
 
"If I put my finger on the unconnected end of the IC, the humm sound get a little louder."

That would suggest that your cables have rca connectors. Your picture shows old Krell amps. I'm pretty sure you need to have the pins in if you are using SE cables. If you don't use pins, then there should be a switch somewhere. If that's not it, you may have a damaged cable or connector.
mikeba316's avatar
mikeba316 OP
65 posts
 
My system pic is very outdated and old. Those were Lamm amps. I have single ended connectors. I have VAC 300.1a amp now
bojack
647 posts
 
This happened to me a while back, and it turned out that one of my ICs was touching one of the metal bars on my rack. Even though the IC was insulated, this caused a hum in that channel (odd). I also got a hum once when my pre's IC was touching my CD player's chassis. I would look very closely at how your cables are oriented to make sure they are away from these.
Log in to respond
More to discover
80x80
Avanti Audio Vivace & Allegro DEMO
80x80
Avanti Audio Allegro Speaker Cables
80x80
MIT Matrix 50 Proline 1.5m XLR's