Volume Control Conrad Johnson DR-1


I have a Conrad Johnson DR-1 Ttransport that I purchased from a fellow Audiogon'er that came with a Classe remote (original remote lost). I put the unit in storage as I had not yet purchased a DAC, and when I was ready to start using the unit I realized that the Classe volume +/- controls did not adjust the volume. Anyone know of a manual method for adjusting the volume (no volume buttons on the Dr-1 - a remote function only). I do not want to use direct to my amp but just want to be sure when the volume level is set at. I know I can contact CJ customer service...just wanted to try here first. Thanks.
bsmith15
Thanks Jond. The volume control issue came up when I was just flipping through the DR-1 manual. I have had several CDP's with volume controls but I had never heard of a volume control on a transport before. The manual goes into length regarding the volume setting especially when using the transport with a DAC that has HDCD capabilities. Transport play's and sounds great, just seemed strange. I may e-mail CJ customer service just to see what they say. Thanks again.
I would assume that the DR-1 would reset its digital volume control to max whenever it would be turned on and off. If you happen to have another transport/player arround that you could also plug into the DAC, or just another source, switch between and "see" if the volume out of the DR-1 is lower.
Ultimately you could contact CJ, they would be able to tell you. They have excellent customer service.
It's likely that the Classe remote was meant to control an integrated amp or preamp as well as a cd player, hence the volume controls. However if the DR-1 is just a transport as you say it wouldn't have a volume control as it would need to output a digital datastream to a dac in order to play music. There are full-function players with volume control and dacs as well, but never transports. Hence unless you DAC has a volume control you'll have to use a preamp of some kind. Hope that helps.