2. analog
  3. 182973-180550

Turntable Hums after an hour

I have a Pro-ject 1.2 turntable which, after about an hour of playing, starts humming from where the pulley is.  Took it to a repair shop but he couldn’t duplicate the problem. He tested it with the belt exposed and platter off.  I know nothing, but when I duplicated his test with the platter off, it took longer for the hum to show up, but it eventually did. It seems to happen when the plate where the turntable pulley is attached gets really hot.  Any ideas what it might be. Repair guy cleaned it and said everything inside looked fine. Going to take it back to him but he seems stumped. 

qialah
6 responses Add your response
Ag insider logo xs@2x
cleeds
5,948 posts
 

Have you lubricated the motor?

hoytis
93 posts
 

Yep, lube it up:

https://www.vinylengine.com/turntable_forum/viewtopic.php?t=123254

qialah OP
9 posts
 

Thank you. I did try dripping oil in from the top into the pulley a while back which helped for a while. Maybe I can figure out how to do it from the bottom. Is plain old 3 in 1 oil OK?

petg60
1,486 posts
 

As the noise appears after some use a light drop of thin oil, upper motor bearing, would probably make it run quiter, nevertheless get your technician to check parts and voltages on the power supply also.

 

 

 

qialah OP
9 posts
 

Follow up. Took it back to the guy. It’s a bad coil in the motor and maybe the magnet is weak.  But he if I understood it, said this is an 8 volt AC motor and what Pro—ject sells now is some other amp DC version so he can’t fix it. Am I screwed?  

petg60
1,486 posts
 

Why don't you ask Project?

You can still order a replacement one or get the new DC motor plus the hardware.

 

 

Log in to respond
More to discover
80x80
Palmer Audio 2.5 Turntable
80x80
Acoustic Signature Invictus Jr. Turntable
80x80
Kuzma 4 Point 14”