Tube recommendations for AES AE-3 Preamp

I bought a pair of Sylvania GTB chrome domes from a well-regarded seller on Audio Asylum and in a Cary Sli-80 amp they are very quiet and sound superb. Good choice.

I have yet to find a chrome dome Sylvania to be noisey.
The EH's on the other hand sang like a bird.

Al. Wise

Hmmm...I would certainly hope they're quiet, but like I said I'm new to tube components so I may not recognize abnormal levels of noise caused by defective tubes. Any thing in particular I should look out for

Make sure they are quiet. Many of the preamp tubes for sale in cyberspace are noisy.

Thanks for everyone's input. I found a good deal and settled on some matching NOS Sylvania GTB black plate chrome domes....

Anyone have any experience with these tubes?

I have an AES AE-3 Mkii preamp and after some tube rolling I settled in on vintage yellow writing Sylvania's.
The vintage Tungsols had a bit less of a soundstage as did the RCA's.
The new production EH's were my least favorite.
Also, I replaced the stock GZ34 rectifier with a vintage, early 60's Mullard GZ34.
It mates up well with my AES Superamp Mkii as well as my just completed Bob Latino M125's.
I love the sound of this little preamp and the remote is a convenient feature.

Al. Wise

Though they will not equal the likes of Sylvanias, I have two recommendations for low cost tubes.

Raytheon and the silver colored metal based Shuguang 6N8P. Both sound satisfyingly good, at pricing that comes in lower than the lousy sounding current production out of Russia and China.

I had an AE-3 and later a DJH. The best tube--to my liking--was 6SN7GTB RCA silver label. It had a fleshy bottom end without sounding bloated, and a midrange to die for. I also liked Sylvania, but I kept coming back to the RCAs.

I had the AE-3 DJH for awhile and had good luck with vintage Sylvania VT-231 and Tung-Sol 6SN7 tubes but was also happy with the reissue Tung-Sol and that might be a good fit if you're on a budget.

Best advice I could give would be to email Jim McShane at McShane Design and tell him what you need and how much you have to spend.