Technics published thier compliance figures at 100hz.I believe most cartridge manufacturers measure the compliance at 10hz.So 5-15x10cm/dyne would be more like 10-30x10cm/dyne.Someone correct me if im wrong.
Hello, Aronesss, congradulation on your purchase. I can refer you to Vinyl Engine for an owner's manual for the EPA-100 T/A, a low mass unit. Technics recommends cartridge compliances between 5 to 15x10-6 cm/dyne. A good place to look might be the post and follow-ups from Rauliruegas describing a number of high end mm cartridges.
You must have a verified phone number and physical address in order to post in the Audiogon Forums. Please return to Audiogon.com and complete this step. If you have any questions please contact Support.
