Preamp with external processor loop

I wish preamp makers would recognize that and give us more options.

Luxman and Parasound are among makers who include them. :)

Quicksilver Preamp has a tape loop. You can get it with a remote .

I guess the HT bypass doesn't work in the situation where the external processor is a passive equalizer only (ie no preamp controls). 

High end audio discourages the use of tone controls and equalizers. But those of us who have extensive LP collections, some of the albums are very old and having some control over tone is acceptable and even sometimes necessary. I wish preamp makers would recognize that and give us more options.

I am able to rig this up using a preamp with ability to select source and playback separately using tape loop, but modern preamps even omit those. 

Ugghh.

Thanks soix and gakerty. Will be looking into both the options youve shared. 

The Rogue RP7 (I have one) has a processor loop, and the remote has a processor on/off.  I have a Schiit Loki in the loop I use sometimes, mostly with lower level later night listening for bass boost (like a loudness button!), or with subpar low bass recordings.  

You don’t need an HT bypass at all.  You can use any line-level input (let’s say Aux) and just level match that with your processor.  What I did was set my preamp’s volume knob to 12:00 in Aux and then matched the rest of the processor’s channels to match volume with that.  Then all you have to do is switch to Aux and put volume knob at 12:00 and you’re done.  HT bypass is a little more convenient, but not necessary.  This also opens up a TON more options for you for a preamp. 

 Tape loop lets you set whatever you want as input, then there's a separate "Tape in/Tape out" switch.

Tape out is normal, Tape in lets you hear what the processor is doing.

Thanks ws.  I will do some searching on that.  Cheers!

Quite a few of the Conrad Johnsons have processor loops - my Premier 14 has two. It also has remote control.

Thanks Eric.  It will be used to loop in another processor.

I understand the tape monitor loop works the same way, but doesn't that mean that the tape loop (example Tape 1) is the only thing that could be selected on the Input selector for the preamp?
I don't know how the HT Bypass works exactly - but assume something similar.
(Pardon the ID change - I created a new ID to post and then Audiogon was kind enough to get me back my old ID.)

There are two kind of related and common features:

Home Theater Bypass: Volume is bypassed and input sets the volume.

Tape loop: Just like your processor loop. Outputs the full input, and receives the result. Volume control comes after.