Power Help - What Conditioner - WHERE?

That’s a lot of stuff. The best would be to connect the minimum for a 2 channel stereo in one location and to a direct line. A power conditioned for the streamer through turntable through preamp… and amp in the other socket. I’m trying to be realistic… most of your equipment is modest.. so you don’t want to get carried away.

Then move the rest of the stuff as far away as possible, different room.
 

If you have no choice but combined HT and audio… not a great choice… same deal.

let the power conditioner (s) be priced appropriately… like on the order of cost of a good component in your system. Look to Shunyata, or IsoTech. 
 

The best systems have the fewest high quality single function components in one location. An ideal system today is a high quality stand alone streamer, DAC, Preamp and amp with a power conditioner for everything except amp. 

Furman P-2400 - 20A with built in voltage regulation, series mode protection and linear filtering.  

The one caveat is that for any power conditioner you run into the issue of attaching dirty power supplies to the clean side and re-polluting it, even with multiple filter banks. 

If you run a lot of wall wart appliances like switches, Roku, etc. you may want to add a separate PST-8 just for them or use iFi power supplies. 

And for sure, keep your PC/laptop supplies out of your clean power side. 

Furman power conditioners don't improve sound

we would recomend  using two conditioners one for your amplifiers

and one for other devices

our very large reference theater uses two conditioners 

main conditioner clarus concerto completely non current limiting list 4,000 

the we use an isotek sigmas for the rest of the system

dave and troy

Audio Intellect NJ

Thanks for the input guys. I am trying to use the equipment I have already acquired. I have the XE-12, but it is not in use. Lots of outlets. Full 20a connection. I also have the two BPT units. The Balance Power BP-2 is 15a and the BP-3.5 is 20a. I am pretty sure if I connected all of this equipment via the 20A circuit, we would have enough current/amps, but I am open to discussion of using one of the BPTs to be dedicated to my wall wart stuff. Challenge is much of it ends up back in my Pre/Pro, and if I understand my reading/research, I am better off putting all devices off that single circuit?  If yes, what order? XE-12 to power the BPT units, and then connect all my Pre/Pro - Source equipment to the smaller BP2, and the Amplifiers to the BP-3.5?  With all these wall warts, I will need to use a power strip that better handles their configuration.