2. analog
  3. 1286664320

Need some help with setting up a Lyro Delos

Yesterday I got a Lyro Delos cartridge. After mounting it and setting it up I connected to a setup transformer set at 10X and got ready to be amazed. Well didn't go as well as expected. The transformer seems to be giving it to much gain and I am getting the same noise you hear when the volume is at 100% and music is not playing. My pre-amp has a built-in tube MM phono stage that I connected the transformer. I also have a Project II SE box to "play with" but that to is giving me the same problem .Maybe I am not setting it to the right level, this one is connected to "AUX". These are the specs for the cartridge, any help would be greatly appreciated.

# Builder : Yoshinori Mishima (final build, testing), Akiko Ishiyama (primary build)
# Type : Medium weight, medium compliance, low-impedance moving coil cartridge
# Frequency range : 10Hz - 50kHz
# Channel separation : 30dB or better at 1kHz
# Cantilever system : Solid boron rod with Namiki microridge line-contact stylu (2.5um x 75um) and one-point suspension, directly mounted to cartridge body
# Coil : 6N high-purity copper, 8.2ohms internal impedance, 9.5uH inductance
# Output voltage : 0.6mV@5cm/sec. (CBS test record, other test records may alter results)
# Compliance : Approx. 12 x 10 cm/dyne at 100Hz
# Vertical tracking angle : 20 degrees
# Cartridge body : One-piece machining from solid aluminum billet
# Recommended tracking force : 1.7g - 1.8g (1.75g preferred)
# Recommended load directly into MC phono input : 91ohms - 47kohm (determine by listening, or follow detailed guidelines above)
# Recommended load via step-up transformer : 5 - 15ohm (step-up transformer's output must be connected to 47kohm MM-level RIAA input)
# Recommended tonearm : High-quality pivoted or linear (tangential) tone arm with rigid bearing(s), adjustable anti-skating force, preferably VTA adjustment
veteq
3 responses Add your response
bpoletti
1,552 posts
 
What kind of transformer? Are there taps that allow for lower gain? What kind of pre-amp?

Try running the Project II SE into the AUX pre-amp inputs. Use the MM settings on the Project II before you try the MC. When you get around to trying the MC setting on the Project II, turn down the volume on your pre-amp before playing a record.

The cartridge will amaze once you work out the set-up.
veteq OP
3 posts
 
The transformer is by bent and the preamp is a mcintosh c2200
The mm setting on the project II is better but the volume is very low, I have to reach 80% volume before it sounds ok. The cartridge seems to be very good, great detail compared to the one it replaces.
bpoletti
1,552 posts
 
Change the Project II SE setting to MC, keep it plugged into the AUX input and start with the volume turned down on your pre-amp. Work it up to a normal listening level. That should get you close.
Log in to respond
More to discover
80x80
Garrard 401
80x80
TriangleART Anubis Turntable
80x80
Transfiguration Audio Phoenix MC cartridge