Need Klyne Audio SK-2 manual for dip switch set up

Have you tried to contact Stan Klyne?  He is located in the state of Washington, and I think you can still contact him from the Klyne Audio website.  He worked on my 6LX only a few years ago and was very helpful with related information.

Check vinyl engine and hifi engine if you have not already done that.

Here is a link to the SK1 dip settings.I’mpretty sure they will be the same.
http://cheaptubeaudio.blogspot.co.nz/2010/09/klyne-sk1-phono-pre-preamp.html
With my SK1 I found the best way to set it up was to start with highest load and start with the 76k high frequency contour. Then go down the high frequency contour options ( 76,65,30 etc ) until it gets worse ( over damped ).Then go back up 1 setting. I have a full SK1 manual if you have somewhere I can send a copy to.
Important note - the Klyne phase inverts - you need to reverse the cartridge pins.  

Thank you everybody. I am awaiting answer from Klyne Audio. 
If I get something, I will share.

I got an answer from Klyne Audio.  

SK-2 Moving Coil Preamplifier Switch Schedule
Input Impedance   (Switches 0-4)
(Impedance / Closed)
1000 / None, 200 / 0, 120 /1, 80 / 0 & 1, 65 / 2, 50 / 0 & 2
40 / 0, 1 & 2, 30 / 3, 25 / 1 & 3, 20 / 2 & 3, 15 / 0, 1, 2 & 3, 10 4

High Frequency Contour (Switches 5-9)
Contour Switches / Frequency Closed
60 KHz / 7, 40 / 6 & 7, 25 / 5 & 8, 20 / 5 & 9, 18 / 6 & 9, 16 / 5, 7 & 9
15 / 6,7 & 9, 14 / 5, 6, 7 & 9, 13 / 8 & 9, 12 / 5, 8 & 9, 11 / 5, 7, 8 & 9, 10 / 5, 6, 7, 8 & 9

Also be noted SK-1 and SK-2 are phase inverted.