Here is a link to the SK1 dip settings.I’mpretty sure they will be the same.
http://cheaptubeaudio.blogspot.co.nz/2010/09/klyne-sk1-phono-pre-preamp.html
With my SK1 I found the best way to set it up was to start with highest load and start with the 76k high frequency contour. Then go down the high frequency contour options ( 76,65,30 etc ) until it gets worse ( over damped ).Then go back up 1 setting. I have a full SK1 manual if you have somewhere I can send a copy to.
Important note - the Klyne phase inverts - you need to reverse the cartridge pins.
http://cheaptubeaudio.blogspot.co.nz/2010/09/klyne-sk1-phono-pre-preamp.html
With my SK1 I found the best way to set it up was to start with highest load and start with the 76k high frequency contour. Then go down the high frequency contour options ( 76,65,30 etc ) until it gets worse ( over damped ).Then go back up 1 setting. I have a full SK1 manual if you have somewhere I can send a copy to.
Important note - the Klyne phase inverts - you need to reverse the cartridge pins.