Magnepan MG1.7 fuse question

@Jwpstayman If you are driving the amp into clipping, you are an idiot, and certainly not an audiophile!

The back of the panel is a 3AG Fuse 4amp. One recommendation I can suggest to you is the Furutech TF-4A (32mm), would be a great upgrade from that. We sell them if you are interested.

Just added 4 jumpers from Karl at Empirical Design to my 3.7's. Have listened about 10 hours worth. I'm hearing a little more pronounced midrange and a bit smoother highend. Nothing earth shattering but definitely a change. He also mentioned that if I was interested in another tweak that I should look into the Supreme HiFi fuses.

Don_c55 - one should NEVER tell someone to bypass the fuses on these speakers without knowing the full story. The tweeter(s) will fry anytime that the amplifier clips and not knowing the amp being used or the listening levels, the best though on this should be"run your speakers and amplifier for 6 months and if the fuse never blows, you MIGHT consider by-passing it for even greater performance gains."

If you don't playback at very loud volumes that drive your amp to clipping you do not need any fuse at all!

I suggest brass or copper tubing cut to length in place of a fuse.

Fuses only degrade the sound IMO.

I remember that burned tweeters not covered and You make a good point to install the correct fuses.
Thanks

I've heard first hand how the HiFi Tuning Fuse improve the Magnepans, the best improvement one can make to the speakers for the least dollars. Its good to have the correct fuse value now, thanks.
Empirical Design Jumpers are new to me, really interesting, I'll have research this.

I remember that burned tweeters not covered and You make a good point to install the correct fuses.
Thanks

HiFi Tuning Supreme 4 Amp Type 3AG.
Empirical Design Jumpers.

This is from the 1.7 manual:

The terminal plate states a maximum fuse value of 4 amps Type 3AG ("normal" or "fast blow"). The bass section
does not require fusing protection. This fuse value should never be increased or bypassed. Do not use slow-blow
fuses. BURNED OUT TWEETERS ARE NOT COVERED UNDER THE WARRANTY.

5560, I found upgrading fuses on my 3.7's from stock to Audio Magic LA fuses was well worth it. I can't tell you what amperage the 1.7 uses. I would wait until you get the speakers at which point you will be able to tell what amperage to replace them with. They will be fast blo fuses. I also found getting rid of those nasty stock jumpers to be very worthwile. Both of these tweeks resulted in an immediately noticable reduction in grain.

And you're doing this because Magnepan doesn't know what they're doing when they spec the fuses for their speakers? Spend your money on better source matl., it will pay off much more handsomely...

-RW-