We just fixed and upgraded a Prima integrated amp a month ago.
I can fix/repair or upgrade if you want.
We are in New Jersey.
I can also put you in touch with the guy who we did it for.
I believe he found me with a post on Agon.
PM me if you want
Left Channel Out Primaluna Dialogue Premium
Hey folks. So I turned on the stereo last night ready to listen to some tunes when it was clear there was no volume at all coming from the left speaker. Right channel sounds just fine. I did some speaker/cable/source switching and swapping and determined it was the integrated amp. It’s a Primaluna Dialogue Premium which is the predecessor to the EVO 300.
I swapped out all the tubes, still nothing. Did some research and stumbled on some info regarding the fuse. I can replace that today but if it was the main fuse, wouldn't both channels be out?
I came across a similar thread on here from @whacky who mentioned a left and right channel fuse.
”There are separate fuses for the right and left channel. Not just the main fuse. they are contained on inside a small fuse holder on the left and right side after you open up the underneath.”
Problem is, I can’t seem to locate an internal left or right fuse. Nor can I locate any kind of PL schematic that shows where this fuse might be. I have a message into Upscale and maybe they can point me in the right direction but I thought I would reach out to all the fine folks here for some assistance.
Any other thoughts as to what the problem might be? If it is a left channel fuse, where is that guy located? Thanks for your help!
- ...
- 31 posts total
i’ve had exactly same issues like you with the Primaluna Evo 400 preamp before. I did swap tubes and change the cables but it didn’t work. And you know what, I’m thinking about may be there is issue with the tubes, and I waited until late night , I turn off the light and turn on the Evo 400 and I spotted one of the 12AU7 is die on one of the tiny diodes. And I just ordered one 12AU7 to replace and the problem is solved . Hope this helps. Sorry for my English. ;)) |
@bryannguyen It might be one of the 12AU7 tubes. I’m hoping that’s the case but I’ll take a closer look at everything tomorrow night. @bigkidz I sent you a pm
|
I would think you need to turn amp upside down and remove some screws and check the fuses that protects the circuit in case of a tube failure. I don’t have a Primaluna but would think all tube integrated amps may be similar. I have a Conrad Johnson cav45 S2 and had same exact thing happen. I watched one of the left power tubes red plate and left channel went out. Right channel never skipped a beat and kept on playing. I called Conrad Johnson next day and explained what happened. They told me to replace fuses with very specific fuse and there is nothing to worry about. I told him it was a shame I lost one of my 1960’s Mullard fx2. His reply was tubes red plate sometimes and take out fuses just plug the fx2 back in. I was very skeptical about my tube. I ordered about 10 fuses. When fuses came in I plugged in fuses and tube that red plated and it’s been running no issue for almost a year. Good luck I’m sure you will have it up and running very soon. |
- 31 posts total