2. amps-preamps
  3. 149794-2897

Increasing volume

Hi all
I have an Octave HP700 with the phono stage module & a Lyra Skala. The gain in the phono module is on the low setting & the recommended load according to Lyra is 95.3ohm...I have it set at 97.

I want to drive the pre a bit more but it's quite loud at  the 10 o'clock position. 
Am I doing something wrong?
Any suggestions on how I can drive my pre a bit more...?

Thanks 
Rich
128x128infection
6 responses Add your response
millercarbon's avatar
millercarbon
12,531 posts
 
One of the more common misconceptions, that the position of the volume control knob has anything to do with anything. It does not. YouTube has a highly informative video on this. Search for "Spinal Tap amp goes to 11."
infection's avatar
infection OP
808 posts
 
Excellent, very informative...
yogiboy's avatar
yogiboy
5,661 posts
 
If it is too loud at the 10 o’clock position something is not right. A preamp should work best in the upper range of the volume dial. Are you sure that the phono module is correct for the output of the cartridge that you are using? You should contact Octave to make sure you are using the correct phono module for the .5 mv output of the Lyra!
infection's avatar
infection OP
808 posts
 
@yogiboy  thanks for your reply. Any ideas about possible causes...?
yogiboy's avatar
yogiboy
5,661 posts
 
@infection
Did you contact Octave? You have too much gain. What power amp are you using? What speakers are you using? Did you always have this problem?
infection's avatar
infection OP
808 posts
 

@yogiboy  not spoken to Octave yet...I'll speak to my dealer later.

My amps are W4S SX-1000R monos & my speakers are Audio Physic Avantera III.

I did incur the problem before but altered the gain setting in the phono module.& it seemed fine.

I have recently introduced a new tonearm cable but surely that wouldn't be the cause ...??

Log in to respond
More to discover
80x80
Ayon Audio AYON CROSSFIRE P/A STEREO AMP
80x80
Conrad Johnson Art 300 mono block
80x80
Rogue Audio M-180 Dark