Hum from VPI Scout Stock Motor

Thanks Stereo5. My mistake. The upgrade is to the 300 rpm motor.

I find the upgrade motor quieter and the speed steadier. The pulley is also larger, which, at least for me, made the belt stayed in place better. If I were going to replace anything, I would stat with the 300 rpm motor.

The upgrade is the 300rpm motor. The slower speed makes it much quieter or so they say.

Could you describe the improvements you gained with the upgraded motor? Thanks

You can upgrade to the 600 RPM motor for $150. It is a good upgrade for not much money and will improve the sound. You can get one from Music Direct. Just make sure you have the right one for your turntable size. I use one on the old acrylic platter and think it it was a very good upgrade for not much money. Requires modest ability to put the new motor in the old housing.

The Scout is 10-12 years old.

Is this Scout new? Or has the noise just started on an older table?

Try lubricating motor bearings. VPI has it's own oil, but trivial pistol oil should be OK. If accessible, open and clean bearings and anchor first. You may want to use compressed air if you have such.