How to set the Dunlavy SC-IV signature correctly

Some random quotes for your specific needs from Dunlavy's old web site: "Loudspeakers should be located along a wall facing the shortest dimension of the room for most accurate reproduction of bass". "It is usually best if the distance of a loudspeaker from the side-wall does not equal the distance to the back wall." "For a typical room of average size, e.g. 8 feet high, 13 feet wide, and 20 feet long and a listening distance of from 8 to 12 feet, a good starting distance between the loudspeakers and the backwall would be approximately 1 1/2 to 2 feet ands a distance to the side walls of about 3 to 4 feet.""After listening for several minutes of music at these distances, either shorten or lengthen the distance to the back walls by about 6 inches and determine whether of not the change made an improvement in the overall spectral balance. Patient expermintation with different distances will usually be necessay before optimum distances to the back and side walls are discovered.""If, in the "AVERAGE ROOM"* described above, the listening position is located against a long wall (20 feet) at its center (10 feet from each end) and the loudspeakers are located along the opposite long wall, about 3 feet from the back wall and 4 feet from the side-walls, the angle subtended from the listener is about 65 degrees and the listening position within an "average room" represents a good staring point." "The angle subtended by the speakers from the listening postion should exceed about 60 degrees (the distance from the listening position to each speaker should be less than the distance seperating the speakers).""Research accomplished by DAL has shown that a 4 foot wide by 7 foot high sheet of 3 to 4 inch thick acoustical foam placed on the wall immediatley behind the listener can often turn a problem-room in to an audio pleasure-palace.""A thick sound-absorbing drape (preferably with a high percentge of wool) between the listener and the back-wall will further mitigate problems from developing at the low-end of the sound spectrum. (A low-cost alternative is to use a 3 to 4 inch thickness of sound-absorbing polyester foam, perhaps 4 X 6 feet affixed to the wall behind an attractive drape, preferably one containing at least some natural wool (which will help absorb mid and high frequencies).
*from table
While there may appear to be some contradictions, I think you get the idea that these suggestions may be a good starting point and you may need to fiddle about with a few inches here and there. BTW, I have had sucess with these recommedations with Dunlavy SCIV's. Good luck!

Hi Chamanad,
Below are two copies of discusions I've been involved in regarding setting up my Dunlavy IVa speakers. Please do not under estimate how sensitive these are to placement and how long it takes to get perfect. If you have more questions first click on my posts, if you wish please feel free to e-mail me.

03/01
I began my placement process by following the 1/3 or 1/5 rule. I started with the speakers 1/3 of the length of my room from the wall in front of me. I then took 1/3 off that dimension to determine the distance from the sidewall. This is a rough starting point as determined by one of a few rule of thumbs. I use the Stereophile test disk #2 and the XLO test & burn in disk which have a series of speaker placement tracks. The first thing I tried was using a white noise (full spectrum) track and walked around my room to locate the amplified and dead nodes. If my seating area (1/3 into the room) coincides (which it did) with these nodes I knew I must change my starting point. I moved the speakers ½" at a time in a diagonal to keep the relationship from the walls. Once I had a rough location with no node problems I tried an out of phase mono recording from the XLO disk. The sound should appear to come from all directions with no discernable source. This proved to be an invaluable track on the XLO disk. I worked this and the white noise tracks back and forth until I again had both working. I then used an in-phase mono track to work on pinpointing (toe-in) the sound to a very small point location. These were my start points, there are a number of other tests which are helpful, but these were my major tests. It was now time to listen to some familiar music. I find female vocal jazz quartets to be excellent tools. The voice should appear to be centered (if recorded centered) and stay in the center as I move side to side and front and back. If the voice is too large, not sounding like it came from a mouth then I'd toe the speakers in. If the spot was too tight I'd toe out more. To get the spot to remain centered I moved my listening spot for and aft until it became very stable. Now using a disk with more instruments I could look at sound stage width. The stage should be as wide as possible without losing my center spot location. Back to the jazz vocal I now look for depth. The drum and bass should appear behind the singer. The horns should have a defined point with space in front and behind it. If this depth does not appear (like mine) I tried moving the speakers forward or back ever so slightly. There is a magic spot that the speakers work with the room to bring it all together. The last thing I look for is bass definition. Again I found forward and back impacted bass. A stand up bass should have a definite location, and the note made from the pluck of the string should appear well defined, almost like a round spot. This needs to remain focused down to the lowest notes. If your not dialed in the note will appear to flatten out, and if real bad it will stretch across your floor. These speaker movements were tinny for me in the end. I'm talking 1/16" and the focus would clear up. (That's after a lot of time to get real close) The entire process took about four hours the first time. I listened for a week and reworked it four or five times. It helps to enlist a friend with good ears who is not so close to the process, mine was very important in the final sessions. Once we were sure of our location, we measured the speakers back and side corners to the wall, it turned out one speaker was slightly off of the other. Once we re-aligned them to be exactly the same, one last toe-in and it was indeed there.
So what do I hear now? Every instrument is easy to locate, even when there are 10-15 instruments. They appear within there own space, with room in front, back and on it's sides. When it's well tuned this should not be a stain to hear, but simply the way it is. The center image is tight ( in a realistic way) and does not move from the center. The stage appears to extend well beyond my speakers, but not so far as to lose the center image. The entire presentation comes alive, as if it's in your room, it took a long time but it is extremely natural and not a strain to find all the instruments on stage. I think it's just trial and error, just keep playing. My friend and I tried to better the sound by starting over once and the speakers ended up within an 1/6" of where they started, just a bit further back. I kind of think there is a spot they belong, and if it's the right one you'll find it again. Some of these features my have had as much to do with the tweaks I've made as did speaker location, I believe they do work hand and hand. I just started a post on the tweaks I did this year, it's titled "the winters lessons". Above all, have fun with it, it's not a race.

08/02
The rule of thumb is 1/3 into the room. If that doesn't work for your room 1/5 is the next best. Your seating position also should follow that rule. If this doesn't work for seating, Lugnut's comment of "experiment with absorption behind the listening position" is what you will need if you end up 1/5 or right at the wall as recommended by Audio Physics and Dunlavy. At any rate a min. of 8' and better at 10' between your ear and the tweeter.

The problem you may find in your room is that at 1/5 the depth will suffer, you may need acoustics on the speaker wall to help this.

BTW, I'm set up on the long wall, 1/5 for the speakers and 1/3 for my ears.

Go to Audio Asylum - look under FAQ's - there are several different methods for speaker placement outlined there, including one by Mr Dunlavy (which by the way has never worked for me). My room is almost exactly the size of yours - I have found the Cardas system works well, firing off the short wall (except that my speaker placement is 25% of the length of the room as is my chair. YMMV. Also, a sponsor at AA has a site with a computer program which might help you as well - Rives. He is also an advertiser on this site. Have fun....

Dunlavy suggested setting up the speakers on the long wall, rather than the short one, so use the 6 meter wall if you can; if that's not possible, it's not a problem. You can pretty much spread them as wide as you like, but toe them in towards your listening position (I once heard a pair of SC VIs set up 20 feet apart with no center fill problem at all). Have your listening position be at least 9-10 feet from the speakers, as they need room for the drivers to integrate, much like Thiel speakers. And try to bring them out a bit into the room; while they can be used near back walls (keep them away from side walls), they benefit, as do most speakers, from being away from room boundaries.