How To Properly Bi-Amp (Sonic Frontiers Line 2 to Two Amps to power Infinity Kappa 9's)


I recently purchased a pair of pristine Infinity Kappa 9's and I am looking to biamp them. I have a pair of Kappa 7's that are using a Behringer Europower EP4000 amp and it works great.  The Ep4000 cannot handle the 9's.

I am confused as to how to split the signal coming from my preamp for proper bi-amping. Do I just buy a split balanced or RCA cable? I feel like this would compromise the signal... Or do I use the additional outs on my preamp? My preamp is a Sonic Frontiers Line 2. I believe it has two stereo XLR outs and two RCA outs.

Please let me know.

...also, what is an powerful enough, extremely holographic, silky sweet amp for the mids and top section of the Kappa 9's? Suggestions would be greatly appreciated.

Thanks,
Brett
128x128brettmcee

Showing 2 responses by erik_squires

So, as I was examining the crossover, and thinking to myself "There has to be someone who has improved these..." I found this:

http://www.befr.ebay.be/itm/NEW-Infinity-Kappa-7-8-9-Speaker-Crossover-Filter-Network-Kappa7-Kappa8-...

Based on my own experience modding old speakers, I really like the approach they took. The improvement in the impedance will be far better than biamping (of any kind) could do.

Best,

E
You don't need a crossover to bi-amp. You do need a crossover to get the most out of it.

The other issue is the SF preamp. If you split the output, to a pair of amps you may fall below the recommended minimum impedance.

Also, it may be worth while investigating online mods for those speakers. Some of the Infiinity speakers had really awkwardly designed crossover with terrible impedance curves, which put undue stress and limited output on amplifiers.

Best,


E