Hi Trcns, Are you using the REL SPKON cable? connected to the HIGH level input on the REL? This is the preferred method of hooking up the REL. The REL should be hooked up to your main outs on your amplifier. DIALING IN: Put something on with a good repeatative bass line ...Like LED ZEPP DAZED and Confused, Start with the volume at 1/2, The REL should be in a corner and proper phase selected (louder is the correct one). When Positioning and phase are correct then you can adjust volume to your liking, as a rule I would start with the volume at around 12-1 o clock. SET Crossover to Whatever the lowest freq on your B&W's is, I would set your REL crossover just above where your B&W's drop off. B&W 802D's go down to 34hz so I would set the REL to a setting just above that. hope this helps.
How should I set up REL G1sub woofer
I just bought Rel G1 sub woofer and I read the user manual three times, but it's not replacing someone's experience. I have B&W 802d speakers with which I am hooking it. The problem is even a little base is too much base.
If I tweak it with one song and than with another song either the base is too high or its too low. Any body with experience what is the standard crossover and how high the ever age volume should be on this sub?
If I tweak it with one song and than with another song either the base is too high or its too low. Any body with experience what is the standard crossover and how high the ever age volume should be on this sub?
8 responses Add your response