Some members here have spoken positively about this Cat8 cable that’s not too pricey…
Ethernet
I am adding a HiFi Rose RS 130 to my set up and need to split my ethernet cable run... Here is my question: I have about a 20' run into the splitter , then 2 x 3' runs to the RS130 and a BluSound Vault. I have been using a $20 ethernet Cat 5 cable on the BluSound Vault alone. I am seeing (typical) ethernet runs for $7,000 to $1.50. Where do I go here? Primary goal is to make sure all 3 runs are identical and really NOT thinking of spending a ton here. Thoughts? Cat 5...6...7...?
Help !!
- ...
- 25 posts total
I hope you mean "Ethernet switch" instead of "splitter." Keep in mind that Cat 5 cable has about 100x more bandwidth than audio or even video requires. Going to a higher cat than your source and switch supports doesn't help anything. Using shielded however may help. Also, with long runs you run the risk of picking up an induced surge from a local lightning strike. I encourage you to use a certified isolator (UL60601 or ISA60601) on the side closest to your more expensive gear, or one on each end. More about that here. |
- 25 posts total