Constellation Audio owners

Take it to the dealer and ask them to turn it on for you.

Maybe I wasn't clear. The led is glowing red. I press the bar on the front of the amp and it never changes to the flashing green. I did contact the factory and they gave me a sequence very similar to the manual. I have not tried it yet fearing negative results. Whatever happened to the good old on off switch? Many people suggested to me before I bought this to buy Audionet instead. Maybe I should've listened. Thanks.

I assume you tried all of the above?

A. Make sure the master power switch on the rear of the amplifier is turned on.
B. Check to make sure the AC cord is connected to the amplifier and to a wall outlet.
C. Flip the master power switch off and on again. This will reset the amplifier’s internal circuit breaker. D. Check the circuit breaker in the electrical box to make sure it has not been tripped. If it has, check to make sure a short circuit does not exist at the amplifier’s speaker terminals or the speaker’s input terminals. If no short circuit exists, flip the breaker on and off to reset it.
E. If none of these conditions restores power, it is likely one of the amplifier’s internal fuses is blown. Do not attempt to change the fuse yourself—the amplifier requires the use of special high-voltage fuses that are not commonly available. Contact your Constellation Audio dealer for service.

I would bring it back to dealer and let them verify if it is defective. 

the dealer tells me the same thing the manual says. I’m either dumb as hell or it is bad.

Did you contact the dealer to see their thoughts?