connecting B&W 683s1 to amp? help please?

Yes, they should have straps unless you are bi-amping.

A strap is just a beefy conductor, so short speaker cables can be used to connect between them. 

You can pick either set once the jumpers are in place.

So red to red, black to black.

Don't short the red and black.  That is, do not allow a conductor to touch both at the same time.

damn
pretty sure I dont know where to get these and how to connect it when i do

am I better off bi amping?  im using an old luxman  r113

just cut some bare wire 

can I bi wire using these cables?https://www.infinitecables.com/audio-and-pro-audio-cables/speaker-cables/banana-clip-speaker-cables/...

Just use bare wire for now. :)

i only have 1 set of normal speaker cables and no other wires laying around

so will the above cable and bi wire method work? 

you can bi wire too. Just more expensive.

A single set of high quality speaker cables with jumpers will sound much better than cheap biwire (as seen in your link).
You can strip any piece of wire to make jumpers. Lamp cord or an extra extension cord will do temporarily. Then order a set of jumpers like these..
https://reverb.com/item/15262699-pinetree-audio-crystal-bi-wire-speaker-binding-post-jumpers-9awg-sp...

Or these...

http://www.mazeaudio.com/speaker-jumper-cables.html

thanks all
I'll try the maze jumpers next
bought this cheap set of bi wire cable for now from amazon prime to get going
https://www.amazon.ca/dp/B07P64KRB3/ref=twister_B07P645B45?_encoding=UTF8&psc=1
these 683's are a step up from my pioneers which I think were better than the LS50w's
I'm gonna get a used NAD amp next  (they're plentiful around my parts) as I'm not sure the Luxman has enough juice although it sounds as if it does

also inserted a dragonfly black into the chain which helps a tad, but can't really hear a difference on Tidal MQA compared to my flac downloads

Or some paper clips straightened out will do in a pinch if long enough....