There doesn't seem to be anything wrong with what you're planning to do. Use wire of reasonable quality (shielded single strand is probable better), copper is fine.
Biamping from a 5 channel amp?
So, I have a NAD T750. I am about to get some Monitor Audio speakers (I really hope so at least, but older ones if I can do anything about it). The speakers are biwirable/biampable. Would it be a good idea to hook up the front channel to the woofers and the rear channel to the tweets? This receiver runs 3x50W to the front, and 2x30W to the rear. For the record, these will be some kind of MA bookshelf speakers as I can't afford towers.
Or, if that's a bad idea, I have a newb question. Would it be worth it to biwire these speakers with this amp? I'm not too worried about the extra cost of wire since at my level, there is 0% difference between copper/ofc wiring and silver high end crap. And on that note, do you guys know the profitability of wire? It's ridiculous. And they have you all fooled ;)
On that note though, any recommendations on basic speaker wire? I'll put on my own ends if I have to as I'd like the length to be at least 10ft if not 15 or more.
Or, if that's a bad idea, I have a newb question. Would it be worth it to biwire these speakers with this amp? I'm not too worried about the extra cost of wire since at my level, there is 0% difference between copper/ofc wiring and silver high end crap. And on that note, do you guys know the profitability of wire? It's ridiculous. And they have you all fooled ;)
On that note though, any recommendations on basic speaker wire? I'll put on my own ends if I have to as I'd like the length to be at least 10ft if not 15 or more.
8 responses Add your response