sndsel
Responses from sndsel
| Is DVD a good transport? You might enjoy some reading at tweakaudio.com. | |
| Biamping opinions please. Many manufacturers enable their speakers for biamping. The low freq driver connections and mid/upper connections are typically strapped externally. Speaker manufacturers specify the crossover points and slopes of their passive crossovers. You can ... | |
| Advice on cartridges! It is the compliance of the cartridge not the weight that dictates the use of a higher or lower mass arm. The objective is to place the low frequency resonance of the assembly above typical record warp and eccentricity of 7 - 8 Hz, therefore about... | |
| Ground Wire Material Generally, heavy gauge multiple-strand bare copper is used. In newer homes, most water supply is copper with soldered joints. This is even used by licensed electricians following local code and subject to inspection. In any case, the good point ma... | |
| Anyone heard a Belles 400-A amp? Why not ask Dave Belles? Look up Power Modules under Manufacturers on this site. | |
| 24 bit 96khz. whats the deal? Read about it at tweakaudio.com. | |
| VINYL SURFACE NOISE 86 the Record Doctor and carbon fiber brush (even the best shed fibers into the grooves and they tick). Buy and use a good record cleaning machine - Nitty Gritty or VPI (even a manual model if cost is a factor). For damaged disks (from playing whi... | |
| Best amp for Dunlavy V Hi, Snooky. |