rodman99999

Responses from rodman99999

Tact Pre Amps 2.2XP
Hi Bob- I wouldn't add anything else to the audio chain personally. I can't really imagine a need. I still abhor overprocessing signals, and adding interconnects. The TacT does act as a pre-amp(adds SOME gain)and (as mentioned): is capable of more... 
Got the itch again "real bad" for tube mono blocks
I've been listening to a Pair of Cary SLM-100s for the last three years. Tubed with Tungsol VT-231(round, black plate)for phase splitters, Sylvania 6SN7Ws as drivers and Winged C 6550s(latest iteration from Upscale): the imaging/soundstaging/respo... 
26"-32" LCD HDTV Buying Angst--Toshiba? Sony? etc.
I have a Toshiba 36HFX73 that has treated me VERY WELL for the last couple years. With the DVI input(get a Kimber Kable) the HD picture quality is no less than excellent. Sucker weighs a ton though!! 
Tact Pre Amps 2.2XP
I've been using one for over a year now. I was a die-hard straight-wire-with-gain guy for 28 yrs until the 2.2X came along. I've also been bi-amping for 26 yrs. My last dividing network consisted of a Dahlquist DQLP-1 for low pass/level control/ba... 
Cartridge compliance vs tonearm effective mass
Effective mass is different than the actual "weight" of an arm. The following site will be a big help: (http://www.gcaudio.com/resources/howtos/tonearmcartridge.html) It should answer most(if not all) of your questions. 
Siemens -Halske 6922
I presently have six of the 60's CCa sweethearts in my BAT VK-D5. When I owned my ARC SP9 and SP14 pre's: they were also equipped with the same. The most musical/accurate of the family(if you purchase the 60's version, as mentioned above). The 70'... 
"break-in" period? . . . how to
The CD, 'Irrational But Efficacious' by Ayre Acoustics contains a number of useful tracks, one being uncorrelated, mono, brown noise. This simulates the typical spectrum of music and can be set to repeat for burn-in purposes. I use it, the pink an... 
Got M&K MX-150 THX for Maggies... feelings?
Nsgarch: My earlier system consisted of a Dahlquist DQLP-1 passive Hi/active low filter, which placed all of one capacitor(a polypropylene) in the mains signal path(minimum phase shift). Virtually transparent! I attenuated my volume with a Placett... 
Got M&K MX-150 THX for Maggies... feelings?
Although most planar speakers aren't capable of the excursion necessary for low bass reproduction(and hence: roll off the bass)- It doesn't mean they aren't trying(not to mention the wasted wattage). The sound of your Maggies will benefit greatly ... 
Any opinions on retubeing W/winged c or mullard re
Recently purchased an octet of Winged"C" 6550s(the latest iteration)to replace the Phillips ECGs in my modded Cary SLM-100s. Got them from Upscale Audio after much agonizing over departing from NOS tubes. Much ado about nothing!! They are performi... 
Placement of dual subwoofers...
As Newbee Stated: A source with 1/3d octave tones is most beneficial when setting up a sub/main system. The Stereophile Test CD 2 contains all three decades. Time alignment is ALWAYS critical. My Tact 2.2X allows placement of the subs in the corne... 
Tonearm/cartridge weight considerations
And now pontification trumps experience? How tedious this has become! 
Breaking in a new cartridge,..Denon DL 103 R.
Denon used to provide a frequency response curve with every catridge. I reflected the response of the cartridge and recorded the impedance at which the catridge was tested. If they are still providing that info: Match that impedance and you can't ... 
Tonearm/cartridge weight considerations
There are a lot of modded/rebuilt cartridges out here, just as there are a lot of modded electronics. I suppose: a lot of people that aren't aware of the practice as well. The rubber cantilever suspension makes all the difference in the "complianc... 
Tonearm/cartridge weight considerations
I don't remember saying my DL-103D was still stock. It now sports a van den Hul type I stylus, a boron cantilever and new rubber compliance. Tested as stated.