pbnaudio
Responses from pbnaudio
| x-over resistor replacement query Order 2 ea 22 Ohms or 3 each 33 ohms and place them in parallel for a 11 Ohm value.Good ListeningPeter | |
| Alnico or not alnico ....... what is the bisible d Alnico Drivers from JBL have a bowl shaped closed magnet assembly. Ferrite Drivers typically have a Rubber Dress ring covering the magnet it self with the back more contoured. Go to ebay search JBL woofer and it should be pretty obvious. Some folk... | |
| Cryogenic experience wanted. Constructive please Had an entire Olympia LX preamp with its CPS power supply cryogenically treated Olympia LX There was maybe a very small increase in transparency in the sound produced by the preamp after the procedure.As far as treating cables is not money well sp... | |
| phono pre suggestions Liberty Audio B2B-1 and Yes I do make them :-)LibertyGood ListeningPeter | |
| The Demise of the Hi-End Audio Store Harri009The Soundstation Bartlesville OK is another excellent store in your stateGood ListeningPeter | |
| inserting 2 channel preamp When ever setting up a combined system (HT and 2CH) emphasis is always put on the 2CH then the HT is the add on. Feed the L/R of the receiver into a input on the 2CH preamp, if no HT by pass just use a fixed setting on the volume knob for the HT R... | |
| THE GREAT AC OUTLET SHOOTOUT. Z,Its not completed yet, CES etc got in the way, should have it done in a few weeksThanksPeter | |
| Best long low noise RCA cables Sounds like you have found the culprit of you hum issue :-) , have you tried the Canare wire from Blue Jeans Cable, I have had pretty good luck with it.Good ListeningPeter | |
| Need Dunlavy repair I may have one of them in stock, I think John used the M26WR-09-08 or may be the PL version pull it out and read the Vifa sticker on the magnet.Best of luckPeter | |
| Sick and tired of hum-please read You have efficient speakers so there may be some residual hum from your Canary Amps ( I have a set of REF2) that you cannot eliminate. Start from the very end ie. connect speakers to amps, short the inputs with shorting plugs and turn them on, the... | |
| Moving coil cartridge Just to get your feet wet with a MC cartridge try a Denon DL 103R its inexpensive and you will have to spend much more to get better performance, it is a true steal.Before stepping in make sure your phono preamp have sufficient gain for the LOMCGo... | |
| Phono preamp suggestions Jmcgrogan2It just happens that I'm immensely proud of this little thing, but you probably figured this out already. It is far from a big money maker for us so cut me a little slack will you :-) I could of course post stealth but imo that would not... | |
| Anybody has experience with Building a TAD You may want to check out the JBL 2435HPL also - its a bit more accessible than the TAD drivers.For a interpretation of similar check this one outPBN DB15Good listeningPeter | |
| ???Phono Preamp for Rega RP3 W/Elys2 ???? A bit more than you are looking to spend - but as always you get what you pay for.Liberty AudioAnd i do make them :-)Good ListeningPeter | |
| Phono preamp suggestions Here is a suggestion although a bit more than your budget.Liberty AudioAnd yes I do make them :-)Good ListeningPeter |