noromance
Responses from noromance
| SP10mk2: OMA Graphite plinth vs.Dobbins plinth Try Jim Campbell (ebay jec965). He built my birch-ply and 3" slate plinths. A lot less expensive than OMA. Check them out in my systems. (No affiliation) | |
| Dedicated 20 amp lines/should i use a sub panel I ran 2 x 20amp runs on 10 gauge from 2 side by side breakers for monoblocs. I ended up not using one of them because of a hum loop. Let us know how you get on. | |
| Help with an open circuit Quintet Black Soundsmith? | |
| Turntable upgrade recommendations, please. Look at the Anvil with a Jelco 750 arm (or their 850) | |
| Hum!! @stereo5 Nope. Dry. As in it has "dried" out over the years from not having the flux flow properly and cracked. Cold is a faulty solder joint from the start by not having the iron hot enough. I said connection instead of joint to help clarify in c... | |
| Hum!! Sounds like a dry solder connection. | |
| REL Strata iii connected to Krell KAV-250A I connect my REL Strata 3 to my monos using the high level SpeakOn connection. 3 wire - right ground/right hot and left hot. | |
| Garrad 401 service expert in San Francisco Area No clue. What's wrong? | |
| Low level buzzing coming from tweeters. Turn off amp. Disconnect the pre. Short the input to amp. Turn on amp. This is to see if it is coming from inside the amp or if it is being picked up from ourside the amp. | |
| Speaker distance Quad ESL 57. 6’6" apart from panel centers.Toed in so centers point at ears.(36" inside from front wall.47" outside from front wall.)>36" from side walls.7’2" to ears from speaker centers.18" custom stands. Center of speaker panels level with e... | |
| Filling speaker stands: sand, lead, steel, rice. Full, half, etc? Elizabeth is in the house! | |
| Filling speaker stands: sand, lead, steel, rice. Full, half, etc? Try removing the rubber pad and use brass cones. | |
| Vintage amps Old and not tubes then not worth much unless it's recapped Krell 250! | |
| Sansui 9090db powers up but no sound Why not buy one that works? Seems like you're asking for trouble. | |
| Looking for an ASR Emitter Not sure if this helps. Hifishark.com list all available gear worldwide.https://www.hifishark.com/model/asr-emitter-i |