last_lemming
Responses from last_lemming
| Can't tell,if my house is properly grounded I second Erik's suggestion of having a tech look at it. There is the possibility that a safety cap in the receptacle is leaking ac, especially the one from N to ground. If the fuse blew with that extension cord, it's possible you reversed polarity... | |
| Can't tell,if my house is properly grounded Ok, I did everything everybody said, and there is no change buzz is still there.to answer a question from above I switched the room the phono pre was in and went from single ended to xlr because the tube amp doesn’t have xlr. I have had the same i... | |
| Can't tell,if my house is properly grounded I will try removing the cables tonite. However the TT has no power and is not directly plugged into anything (VPI prime TT). The problem arose when I moved my TT setup to another room and switched to single ended output from the phono pre instead ... | |
| Can't tell,if my house is properly grounded I replaced the fuse and it plays fine. | |
| Can't tell,if my house is properly grounded What TT are you using? Cartridge? I have a Dynavector 20x2L, and the cables are Cardas Clear Light. They have never given me trouble before. I don' t know if this matters but the noise is coming from both speakers, but I assume if one cable was ... | |
| Can't tell,if my house is properly grounded i did try and the polarity reverse to no avail. I also tried a cheater plug, but since I didn't have one designed for that purpose on hand I used an old extension cord for 2 prong components. It had a little bump out on the end to block the ground... | |
| Can't tell,if my house is properly grounded I have cable tv and I turned off all lights when I was checking. Nothing seemed to work. I also disconnected the cable tv. HOWEVER - I diconnected everything but the amp (and speakers) no noise. I plugged in in the phono pre into the same wall ou... | |
| Can't tell,if my house is properly grounded No wall warts and yes I disconnected the computer and cable line going into the modem as well. No change. | |
| Potting a Denon dl-103r Also, a "potted" cart has nothing to do with 'gluing" the body of the cart to the carrier.Can you please elaborate | |
| Potting a Denon dl-103r Interesting. Ive read that potting it makes for better bass response. The fit is snug to the point where a bit of hard pressure is required for the last 1/16th of an inch when you insert it. What at would be the negatives for potting? | |
| JC3+ Anyone? Hey Robert,sorry i I got to this post so late. I Owned a DV P75 Mk III and then moved up to the JC3+. I agree with your assessment of it. I have the VPI Prime with a Dynavctor 20x2 low output MC cart. Mind, I have Thiel speakers too and any thinne... | |
| Tonearm cable recommendations Purist Audio Designnot cheap, but excellent | |
| Adding mass to a tonearm Raul - I have two systems, my "fun" system which has the pioneer Pl-530, and what I consider my "high end" system which has my VPI Prime. I'm only talking about my The system that has the Pioneer, which has the Denon PL-103r. The only reason I w... | |
| recommendations of phono preamps < $3000 range I too have the Parasound JC3+, I have nothing but good things to say about it. Very well built as well. Highs are smooth, midrange is liquid and lows are solid, deep and controlled. | |
| Cartridge repair; re-tipping; canitlever replacement: The Needle Clinic A++ Heck, I nuded my Denon DL-103r being super careful. Got the thing to the point all I had to do was set it down to be done - then for no particular reason at all it just fell out of my hands somehow. It fell all of two inches but that's all it too... |