kr4
Responses from kr4
| 804 Nautilius rear aluminum knob It is factory-adjusted and should not need tweaking. There's usually a bolt that screws into it for transport which is removed at installation. | |
| Best room correction of the ones listed? Won't know the answer until tomorrow. | |
| Bach's Toccata Assuming you mean the Toccata and Fugue in D-minor (the most popular one), my favorite LP is Marie-Claire Alain on Erato.Kal | |
| Bi-Wire - Ohm and RMS Rating Split Don't worry about the ohms. OTOH, you are NOT getting the equivalent of 200w by bi-amping. Barely more than 100w, effectively.Kal | |
| Bi-Wire - Ohm and RMS Rating Split The bass always uses most of the power, so I would think that the 110/440 rating applies to it. The ohms are not divided.If your Rotel is 100wpc, that is all you will get to the woofer(s). If more power is what you want, this bi-amping will not he... | |
| Two-channel is inferior to multi-channel, no? "I just find that multi channel sound provides a flat sound stage with very little depth compaired to two channel system. At least that is what I hear in my system."Incredible. Must be something seriously wrong with your MCH setup.Kal | |
| Does two center channels = one stereo system All of this ignores the horizontal arrangement of drivers in typical center channel speakers. This, alone, compromises spatial radiation and imaging.Kal | |
| Sony SACD 5400 ES: how to get it in standby ? AFAIK, there are no heaters in this player. ;-)Kal | |
| Sony SACD 5400 ES: how to get it in standby ? If you can turn it on/off with the remote, it must be in "Stand-By." It could not respond to the remote if it was really powered off.Kal | |
| Digital inputs in high end 2-channel preamps There are, afaik, three preamps:McIntosh C48McIntosh C50Classe CP800and an integratedHarman/Kardon HK 990.There must be more.Kal | |
| EMM DCC2-SE or Sony 5400ES for HiRez downloads? The Sony has no inputs at all.Kal | |
| Digital to Digital decoder? Sorry. It will only handle FAT/FAT32 USB drives, not the output from a computer.Kal | |
| Digital to Digital decoder? That is a tough one. For a USB output, my modded Oppo would probably do it. For S/PDIF, I am at a loss for anything other than an expensive processor like the Tact, Meridian or Theta.Anything else is a custom job.Kal | |
| Digital to Digital decoder? OK. What is your source connection? Is it S/PDIF with lossy multichannel (like DD) or is it something else?Kal | |
| Digital to Digital decoder? Rare. I have a player that will do it but most such are expensive or custom mods.What are you going to do with those 3 S/PDIF feeds and how will you control volume?Kal |