dill
Responses from dill
| Pass Aleph 3 into 16 ohms You will have no problem at all driving a 16 ohm load with this amp. | |
| Sony xdr-f1hd, Tuner, Impresive great value Send it to Mike at Radio X for a mod for that issue. He also does mods for improved sound. I had mine done and it really improved the sound. - http://www.radioxtuners.com/ | |
| Compact receiver for bedroom These might fit the bill: NAKAMICHI R-1, Marantz 2010 or 2015, some early Sansui where smaller, Denon, Yamaha & Teac made compact systems with smaller width receivers. | |
| VPI HW19MKIV huming motor Mine did the same thing. First plug the motor directly into the wall to make sure it is the SDS and not the motor. Then cycle the SDS on & off a couple of times and see if you can get the table to run at 45rpm. Mine eventually started to work ... | |
| Small integrated for Silverline Minuets I am using one of these in my office driving a pair of Silverline Preludes with a Velodyne sub. I upgraded the tubes and it sounds great, built like a tank. http://www.teconaudio.com/model_SE43i.html | |
| Bi-wire Silverline Prelude II: Is it worth it?? I have the same speakers and use 6' Zu Libtec cables with Ibis jumpers, the Libtecs hooked to the lower posts. I suggest trying some Analysis jumpers. | |
| Prefered Freight Company The old radio collectors ship the large consoles by Greyhound bus. You can only ship from terminal to terminal, but as long as it fits in the storage area, it can be shipped. I hear it is very reasonable too. | |
| switching from isolated ground receptacle No, the isolated ground duplex receptacle is internally configured to isolate the ground. Just attach the white & black wires to the correct sides and put the bare or green wire to the ground post of the outlet. | |
| pass or krell PASS!!!! | |
| Isolation for Home Theater Speakers Get some Blu-Tack, that will cure the dancing. http://en.wikipedia.org/wiki/Blu-tack | |
| re-terminate nordost cables...anyone? They have a termination service. www.moon-audio.com | |
| Outdoor FM Antenna question I am very happy with my FanFare FM-2G. | |
| Used speakers: Cleaning tips? What is dealer dust? Is it different from customer dust? | |
| BNC to RCA adaptor I have a gold plated version, of the adapter, if you are interested. I can send you photos if you provide me an email address. | |
| Jolida JD-9A Phono Stage Hum Problem Well, all the ground wires end at a bolt in the middle of the bottom of the chassis. I took the nut off and removed the "O" lugs and found that there was only a small amount of powder coating removed and the bare metal had some surface rust. I rem... |