dill
Responses from dill
best premp for a pair of pass aleph 30's? A Pass Aleph P or Aleph L would work great. I had an Aleph 3 with the Aleph P and the Aleph Ono for over ten years and only sold them to downsize. I would still have them if I had the space. | |
best premp for a pair of pass aleph 30's? Go with a Pass Aleph preamp and use balanced (XLR) interconnects. | |
Audio Magic Spellcaster - Type of Wire? Just received an email from Jerry at Audio Magic: IT SHOULD BE A MULTI SILVER CONDUCTOR [ HOT ] OF VARIOUS SIZES AND A SINGLE SILVER RETURN. WITH LOCKABLE CONNECTORS. Thanks Jerry. | |
Pass Aleph 3 into 16 ohms You will have no problem at all driving a 16 ohm load with this amp. | |
Sony xdr-f1hd, Tuner, Impresive great value Send it to Mike at Radio X for a mod for that issue. He also does mods for improved sound. I had mine done and it really improved the sound. - http://www.radioxtuners.com/ | |
Compact receiver for bedroom These might fit the bill: NAKAMICHI R-1, Marantz 2010 or 2015, some early Sansui where smaller, Denon, Yamaha & Teac made compact systems with smaller width receivers. | |
VPI HW19MKIV huming motor Mine did the same thing. First plug the motor directly into the wall to make sure it is the SDS and not the motor. Then cycle the SDS on & off a couple of times and see if you can get the table to run at 45rpm. Mine eventually started to work ... | |
Small integrated for Silverline Minuets I am using one of these in my office driving a pair of Silverline Preludes with a Velodyne sub. I upgraded the tubes and it sounds great, built like a tank. http://www.teconaudio.com/model_SE43i.html | |
Bi-wire Silverline Prelude II: Is it worth it?? I have the same speakers and use 6' Zu Libtec cables with Ibis jumpers, the Libtecs hooked to the lower posts. I suggest trying some Analysis jumpers. | |
Prefered Freight Company The old radio collectors ship the large consoles by Greyhound bus. You can only ship from terminal to terminal, but as long as it fits in the storage area, it can be shipped. I hear it is very reasonable too. | |
switching from isolated ground receptacle No, the isolated ground duplex receptacle is internally configured to isolate the ground. Just attach the white & black wires to the correct sides and put the bare or green wire to the ground post of the outlet. | |
pass or krell PASS!!!! | |
Isolation for Home Theater Speakers Get some Blu-Tack, that will cure the dancing. http://en.wikipedia.org/wiki/Blu-tack | |
re-terminate nordost cables...anyone? They have a termination service. www.moon-audio.com | |
Outdoor FM Antenna question I am very happy with my FanFare FM-2G. |