Speaker upgrade itch Opinions 2500$used

S23, I'm running signalCable biwire shotgun speaker cable at this time.

Thanks for all the opinions!
To be honest everyone I haven't heard enough sound improvement in upgrading electronics/cables to justify going that route any longer.

Rather than try to milk the final 3% potential out of my Tylers I would much rather take the leap with a higher quality speaker.
The reason being that I hear little difference in running my rogue 66/88 + CAL CL15 vs my Denon 1801 receiver and Pioneer dvd player (which cost roughly 1/15 the price in total)

So I'm really stuck on making this a strictly speaker upgrade.

Geoffgarcia, IMHO, I can almost 90 percent sure that speaker change will not improve much in your current setup. The Tyler Acoustics reference monitors has pretty good transparent sound. The problem lies in your system setup. If your amp source is not clean before it gets to the speakers ( that's why you can't tell much difference between your denon system) then changing speakers will definitely not help. You can either start everything from scratch or working backwards from speakers.

Just my 2 cents

is that everyone else's opinion too?

Well Geoff, I cant say. I have never heard a single piece of CAL equipment nor have I heard your model of preamp (66), or you speakers for that matter. I have nothing worthwhile to add/detract from S23Chang's opinion. Which I presume is based on the consensus that Tyler's are good performers

I can only offer tertiary opinions. Such as, I have read many good things about the Tylers. But, pointing out the obvious isnt going to help much.

I can add my opinion on another matter. Others, I am sure, will disagree. In my personal preference, I typically find that system's which have an extended high frequency spectrum throw a more 3 dimensional soundfield (holographic). However, there is a downside. Too much high frequency info can be tiresome and some recordings have just that. Again, that is just my personal preference and opinion and clearly audio isnt a "one size fits all" hobby.

I dont want to get off subject, but instead of dropping a wad on speakers right now, you might try cable tweaking. Maybe a copper-silver hybrid. Pure Note Epsilons? You could even start a thread asking what cables give great imaging and a deep 3D soundfield. You can probably buy used and resell with little loss if they dont work out.

The reason I say this, is.....The Rogue's are not bright. The Tyler's are not bright(what I have read) and the Transparent's arent either. It could be cumulative. You may, stress on may, be needing a little "sparkle" to bring out that 3D effect your looking for. And changing a cable or two is a whole lot easier than the others.

Just an idea.

If you really want to scratch the speaker itch, and still have something that mates well with a wide variety of upstream electronics, you might consider Vandy 3ASigs, used should be right about on your target price point.