Turntable help Please

The Phillips tables have more issues with the electronic switches etc than just sounding good. If it spins fine, use it! Get a phono stage, nothing too fancy(radio shack's aren't bad) and run it into the ground. Have to be careful of matching tone arms etc. Some great tables can sound really bad when mismatched. Takes a long time to know what works best with what unless you have DEEP pockets. Keep it simple & enjoy your LP collection with that 777.

As a first step I would recommend getting an inexpensive phono preamp. I bought a ProJect phono box running into my ARC LS-8-II and am satisfied. Then I would connect the old tt and give this a good listen. Only if it convices you of some sound quality you like and that you find is subjectively missing from CD would I continue along the analog trail. If you convince yourself that analog is for you, a new turntable/arm/cartridge combo should be considered. With the renewed interest in analog there is more to chose from now than a few years back. I would look at REGA first, with a Sumiko or Audio Technica cartridge. There are other tts, arms and cartridges at the lower price levels of analog I would look at way before spending for higher end used. With used analog, the stylus is always a worry. I still wonder what this renaissance is all about, since you will have to work mighty hard to feed this contraption. If you kept your vinyl and it is still in good shape, your effort in reviving analog in your system may be better justified.

Pops,

As for a phono stage, NAD, Parasound,and Creek all make MM phono stages for less than $200. I'm using the NAD which I bought here for less than $100.

Not knowing the overall sytem you
have or your budget makes any
recommendation questionable. One
good combination that would last
you for a long time would be a used
Well Tempered Labs unit going for
$ 450 to 650 which includes a good tonearm.
High output Grado cart. is a good starting
point and is more flexible than most MC
carts. recommended previously. Grado's
are a bit warmer and lush sounding to my
ears than the lower priced MC units.
As price and associated gear increases,
so does many of the better/higher priced
items on the market. What I like about Well
Labs and Grado is they are US made and they
respond to e-mails and telephone calls. I
can't say the same for many of the table/cart.
manufactures & vendors.

I'm not familiar with the model of TT that you have, but many mass-market designs typical of the era will display problems like wiggly tonearm bearings, motor rumble, platter resonances, bouncy suspensions, and susceptability to coloration, mistracking, noisiness and feedback in general (especially if they're changers). You may want to take it to a TT specialist for an assessment of its condition and potential before starting down a road with it. It would be a shame if your foray back into analog were disappointed by the wrong tool for the job - peoples' audio expectations have been raised a lot since the time some of these "oldies (maybe not goldies)" were made. Who knows, yours may be worth working with, but there were reasons Linn came out with the LP12!