The metal tonearm tube is your shield.
No shielding needed for the wires in the tonearm.
No shielding needed for the wires in the tonearm.
Technics SL1200 Cardas REWIRE Shielding
I am currently looking to rewire my tone arm. I know that cardas makes a nice litz wire for rewiring tonearms. I have a bit of a technical question. I am hoping to use a shielded wire and I was just curious how to connect the shield within the wand and tonearm assembly?
Does anyone know of a good source to get a spool of this wire, in either shielded or unshielded format?
I believe the wire has the following flow from inside out.
Litz->dilectric enamel-> 4 straight->1 shield for all 4->dilectric.
It sees as though if I had the left and right independently shielded then I would be able to connect to the cartridge as follows left signal left ground, right signal right ground. But since there is only one shield I am uncertain of how to do this properly. Some advice would be greatly appreciated! Thanks a million guys looking forward to hearing from you.
Does anyone know of a good source to get a spool of this wire, in either shielded or unshielded format?
I believe the wire has the following flow from inside out.
Litz->dilectric enamel-> 4 straight->1 shield for all 4->dilectric.
It sees as though if I had the left and right independently shielded then I would be able to connect to the cartridge as follows left signal left ground, right signal right ground. But since there is only one shield I am uncertain of how to do this properly. Some advice would be greatly appreciated! Thanks a million guys looking forward to hearing from you.
- ...
- 6 posts total
- 6 posts total