Cable upgrades
Happy Holidays to all!
I’m reconfiguring my system and am interested in upgrading my interconnects and possibly my speaker cables, and I was wondering if you could make some recommendations.
I was running Audio Sensibility Impact SE XLR between my Benchmark DAC3 HGC (as a DAC/pre) and my Benchmark AHB2 power amp. The amp is running bi-wired Kimber Cable 8TC (I think that’s the model #) to a pair of ATC SCM40 tower speakers. In this setup the bass is tight and the mids are clean - overall I’m quite happy - but sometimes I feel, for my ears, I’d love a bit more openness / brightness in the higher end.
My questions are: would improved XLR interconnects help to open up the top end a bit, without being harsh, and perhaps increase the dimensionality of the soundstage? Or would I be better off starting with upgrading the speaker cables? I’ve been looking at the Cardas Parsec level of cable, and could perhaps stretch to the Clear line, pending your recommendations.
Also, one other question: pending the possible move to 2 AHB2s (in mono-block configuration), do both XLR interconnects have to be the same length? If not, would it cause any timing issues between, say, a 2' XLR and a 6'?
I’d appreciate any guidance. Many thanks in advance.
Best, JAMES
@ghdprentice oh of course. Agreed. Trying out Nordost Heimdall 2 on my Aurender N200 now. Lower than the 10% point of reference. Not an endgame by any means as well but a very pleasant surprise and a sneak peak into what Nordost power cords can do on a streamer. |
@ghdprentice thanks for the rule of thumb info. A very helpful guideline. So, for example, looking for PC and USB for my Lumin U2 ($7,500 Cdn) I’d target cables in the $600-800 used range? And would that spend be for each cable, or both together? And would this apply for most components, given that they would need both AC and interconnects of some kind? @audphile1 What PC were you using before the Heimdall? I’m researching an upgrade from my AQ Coffee USB…and also considering upgrades from stock PCs… Thanks, JAMES |
James…I used Furutech FPS-032n power cable on the Aurender N200. I also tried AQ Tornado. For USB I’m using AQ Diamond and for the Ethernet, Purist Audio. Nordost Heimdall 2 is completely different than the AQ Tornado. Nordost and Audioquest in general sound completely different. I ended up liking the Tornado on Bricasti M3 DAC, Heimdall 2 on N200 and Nordost Frey 2 power cable on Pass XP-22 preamp. Best top to bottom balance so far with low noise floor. My interconnects are Nordost Tyr 2 XLRs so there’s a bit of synergy going on there. |
OP,
Honestly the way I do wires is in phases. Speaker cables and interconnects and stop. I will use the 10% as a guide on those. [understand, I have all sorts of wires laying around from the past 50 years of audiophilia]. When I have finished, I will do additional moving speakers / room treatments. Then I will attack the power cords. By this stage I know my system really well and have recovered financially. So, I will then see how much effect power cords have. So, I guess I have always added those later outside of the rest of the budget. However, the amplifier power cord can often make one of the largest impacts… up there with the speaker wires. If you make sure you get a big sonic impact from each purchase then if you end up spending more it is OK. |
