What happens when the stylus tip wears out on a $12,000 cartridge?

@scott22 - good question. I don’t think there is anyone who would not prefer a factory-rebuilt cartridge to a retip, but as stated above, it’s not always possible, as the maker is  no longer around, as in the case of Transfiguration.  All I can say is this- I cannot recall reading one post here in 10 years where someone has had a cartridge worked on by Soundsmith or VAS that they were not delighted with.  I did have a problem with the suspension after a Soundsmith repair and they fixed it asap.  As far as the same exact sound?  I don’t think anyone will go in record as saying the sound was exactly the same.  Musical memory is too short to make an exact comparison.  But from what I can see, the crusty, picky audiophiles here are invariably satisfied with the cartridges when they get them back.

, 

When one purchases a 10K cartridge they are stepping out on the ledge. No way around it. If you're actually looking and this is more than conjecture the solution put forth by tunes409 sounds pretty good. Phasemation is a very solid brand IMO.

I still wonder how you know your cartridge needs to have the stylus tip replaced? Other than the purchase of a $1200 microscope, how do you know. I don’t track the hours played. Plus, if a stylus starts to degrade, it is a gradual process and I would never know how the sound changed over that lengthy degradation process.

How do you all know when the stylus needs replacement?

@pgaulke60 - for me, after a few years, the cartridge just starts sounding a little ratty, as if the stylus is dirty, or mistracking. You can always just send it to a retipper for an inspection and, at least in the case with VAS or Soundsmith, I think they will be honest about it. If you don’t feel you trust them, that’s another story. 

@chayro Thanks for the response.  I have two turntables, in different rooms, with the same cartridge.  I think I will call these outfits and ask about retipping for my specific cartridge.  Would really like to know if it is worn.  Then, if the one I send in is good, or gets retipped I can put it on the table I use daily, and repeat the process.  Thanks