Adjusting Infinity IRS servo controller

Is there anyone who can provide a copy of the settings/manual for the IRS servo amp. I have a Genesis 2 system and the amp should be checked out to insure it is performing properly. I figure that it may give some insight for myself and others. Does anyone know who made the amps or can service them properly? All help is appreciated.

Mark

Upload the picture into your system page and post it here.

Here are some pictures of the Genesis Servo amp and columns. There is no service procedures on the feedback to be found. You can see the 2 adjustment pots per channel on the board. Any ideas on test procedures for this??

Mark

I don't have any specific info on that Genesis servo, but based on my experience with the Infinity servo, I would suppose that one pot is gain and the other offset.  I adjusted mine for as close to zero dc bias as I could get and the the gain for unity.  You will have to try them to see which one does what.  You will also need access to an oscilloscope and probes.

and how do I set this up without an oscilloscope?

Multimeter I have! (and the plastic "screwdrivers")

Let me know!!!!