2. speakers
  3. 186908-93543

Adjusting Infinity IRS servo controller

I got a request from @bobterry99 about adjusting Infinity servo controllers.  Inside the controller are 4 pots:

Left side level (amplitude)

Left side DC offset

Right side level (amplitude)

Right side DC offset

See the attached photo.  I used a 2 ch oscilloscope to monitor the input and output while adjusting.  With 4 ch, you could monitor both channels...

 

jtucker
ervikingo
131 posts
 

Which version of the servo and which speakers?

BTW, I am looking for a reputable shop to go over my spare servo controller (IRS Beta) to make sure its all up to design specs

jtucker OP
76 posts
 

I had the IRS Gammas.  Sold them back in 2010.  I did a fair amount of work on the my servo controller plus another one (anybody remember Bobby Shred?), but since I am retired now I no longer have access to an electronics lab.

racerxnet
54 posts
 

Is there anyone who can provide a copy of the settings/manual for the IRS servo amp. I have a Genesis 2 system and the amp should be checked out to insure it is performing properly. I figure that it may give some insight for myself and others. Does anyone know who made the amps or can service them properly? All help is appreciated.

 

Mark

imhififan's avatar
imhififan
2,133 posts
 

Upload the picture into your system page and post it here.

racerxnet
54 posts
 

Here are some pictures of the Genesis Servo amp and columns. There is no service procedures on the feedback to be found. You can see the 2 adjustment pots per channel on the board. Any ideas on test procedures for this??

 

Mark

 

More to discover