Adjusting Infinity IRS servo controller

DC offset is adjusted for minimum DC on the output. The level trim adjustments are just that.  Apply a similar signal to each input and adjust so that the outputs are equal.

Thanks for that picture, jtucker. Is it possible there is an error?

Referencing the ECU schematic seen here, it seems to me that you show adjusting potentiometer R30 for the level. But that seems like the wrong one to me.

I think the correct one is R23, since it is controlling the amount of negative feedback of the amplifier comprised of ICa, ICb, and ICc. Potentiometer R30 sets the level of the output from the amplification of the accelerometer signal.

I’m going to see what some of my electrical engineering buddies think.

I suppose it is possible that I made a mistake, but I had to re-calibrate my servo on a regular basis.  Those were the pots that used.  If you have access to a scope, it would be easy to verify.  I'm pretty sure I gave the schematic to the new owner, so I have nothing else to compare.  Also, I ended up replacing all the electrolytic capacitors in it.  As I mentioned, all this was back around 2010, so I don't recall any more details.  If I come across anything else in the next few days, Ill let you know.

Again, thanks for replying.

I ended up tweaking the R30 potentiometers just as you did. R23 didn’t offer the needed range of adjustment. Besides, in my case it wasn’t the correct one to adjust.

My issue was the right channel having much more bass than the left. Testing, I found that with an input voltage of 33mV @60Hz my right channel output was driven to 25mV; the left channel to only 12mV.

The first thing I did was dial the R30 potentiometers fully clockwise. This causes the output of each channel’s accelerometer amplifier to be grounded and eliminates the accelerometers and their circuits as a variable. Now each channel measured the same. Had there been a difference I would have tweaked the R23 potentiometers to make them equal and been done.

In my case I had already determined that the accelerometers were not the issue, since when I swapped the woofer cabinets between channels the right was still louder. So the solution was to tweak the R30 potentiometers to make the outputs of each channel equal.

It seems to me that you want the greatest amount of feedback from the accelerometers that does not cause oscillations. I maximized the feedback by by dialing the R30s fully counter-clockwise. I had no oscillations, but the imbalance remained. So I raised the output of the left channel to match the right by dialing its R30 a little bit clockwise.

If memory serves, I adjusted mine for unity gain.  After I noticed that I needed to continue to make adjustments, I started keeping a log book to track it.  Maybe I can find it, but I threw out a lot paper before my last move, so we'll see.