Re-wiring the listening room: Questions


FINALLY getting around to having some straight runs from the panel to the listening room.

My room is a basic rectangle with the speakers at 10:00 and 2:00, amps at 12:00, and equipment at 9:00.

Currently everything is fed via power near the equipment, also at 9:00, however I do have another outlet at 12:00.

Should I do two separate runs?

If so, do I want both individual runs available at the 9:00 and 12:00 positions?

Currently everything is plugged into an AQ Niagara, I have all digital and analog stuff powered via that same Niagara, however I could foresee adding a second power conditioner/distributor in the future to just serve the amps located at 12:00.

What should I do?

Thank you!

gthirteen

Some thoughts/feedback I got from when I ran my dedicated lines…

  • If you can, run at least three dedicated lines — one for digital, one for analog, and one for your amps (that you may prefer to run straight from the wall) as it’s not terribly expensive to add another line.  Separating digital and analog might not be as important depending on how your Niagara is designed.
  • Run 20-amp lines with at least 12/2 romex.
  • Run all lines off the same leg, and don’t share the lines with other household equipment.
  • Get some good outlets.  I’d recommend CruzeFirst Maestro outlets for both performance and value…https://www.cruzefirstaudio.com/maestro

Hope this helps, and best of luck. 

@gregdude

Not true. Ground loops are created by plugging in to two different circuits with different shared outlets… creating a differential in resistance. There is a trickle of current between the two,  When you have dedicated lines that does not happen.

 

 

@ghdprentice Personally, I would run three dedicated lines. One line at 12:00 and two lines at 9:00. That should cover any additional growth and give you an opportunity to keep digital equipment on its own line.

 

 

 

 Report this

ghdprentice

5,081 posts

08-25-2023 at 03:35pm

 

+1

 

that sounds an awful lot like 3 separate circuits, each with a possible different ground potential. 

I believe you intended to suggest 3 branches on the same circuit. Please clarify if I misunderstood 🙂