FWIW I built my own power cables using Furutech bulk cable and connectors. You can buy what awg you want as well as shielding. I made mine custom length to each component. I bought cable covering from Amazon and some shrink tubing for the ends. It was fun project. Cost was around $170 per cable. You can buy less expensive connectors if you wish.
Do I need 10 gauge power cord if I have 10 gauge from panel?
I just installed some dedicated circuits with 10 gauge electrical wire. But now I have to consider replacing my amp power cords because they are 14 gauge or higher.
Is this really necessary and any recommendations on quality 10 gauge power cords that I should buy?
- ...
- 84 posts total
@ditusa : my apologies after seeing your big Crown amp. How many wpc at 8/4/2 ohms? My Perreaux 2150B does 340/680/920@8/4/2 ohms. I will look and see what gauge power cord is on it. Also I was wondering if the MacIntosh 1000 watt mono amps use a 10 gauge or better cord? |
@61falcon Wrote:
Crown says current draw is 23 amps @ 120 volts AC. See manual below, page 33 figure 8.1 Studio Reference I power draw, current draw and thermal dissipation at various duty cycles. Mike
|
- 84 posts total