What is the best tonearm for a SOTA Nova turntable?

Holmz, it’s actually voltage based amplification from cartridge to speakers, if you exclude the aforementioned low internal resistance, LOMC cartridges. Although even that’s an oversimplification.

At least one site says;

The magnets + coils assembly constitutes a miniature current generator

I finally got the Kiseki mounted and set up. It sounds pretty nice. I listened to "Cantata Domino" and Jazz at the Pawn shop, both Proprius recordings. I'll listen some more this afternoon, but my comparison to digital streaming is still that with digital, voices and instruments come out of a darkness that analog can't match. Of course the dynamic range of digital is much better. Soundstage and imaging is better with digital as well. But perhaps, analog sounds a bit more real.

I doubt that a new table  or arm, or phono stage is going to fix these deficiencies unless I spend a whole lot of money. 

Holmz, you could change the predicate of that sentence you quoted to …”constitutes a miniature voltage generator “, and the sentence would be equally correct or incorrect. It’s the impedance at the interface that determines whether you’re in current mode or voltage mode, and apart from the special case of a LOMC cartridge with very low internal resistance driving a current mode phono input with an even lower input impedance, downstream devices drive a high input impedance, in voltage mode.

I doubt that a new table or arm, or phono stage is going to fix these deficiencies unless I spend a whole lot of money.

@gyneguy225 I have not heard “Cantata Domino” but I have the other one on both LP and later I got the CD.
I would be listening to those at shops with TTs.
Which is what I did back in the day when I was shopping for gear… going from shop to shop with some LPs in hand.

i suspect that you are correct with the whole lot of money part, so it may be better to not pursue it. Digital can sound great.

Holmz, you could change the predicate of that sentence you quoted to …”constitutes a miniature voltage generator “, and the sentence would be equally correct or incorrect. It’s the impedance at the interface that determines whether you’re in current mode or voltage mode,

@lewm

Yeah - but technically it is a current device. I does not become a voltage device until we apply Ohm’s law and force the current across an impedance.

… and apart from the special case of a LOMC cartridge with very low internal resistance driving a current mode phono input with an even lower input impedance, downstream devices drive a high input impedance, in voltage mode.

I agree… but down at the speaker that is also a current device.

I get how they are voltage controlled, but I always pondered the fact that a dynamic microphone and cart are current devices on the incoming side, and a speaker is a current device on the outgoing side.

I am only saying that it makes me do a chin-scratch.