2. cables
  3. 168757-11005

I'm looking for a pair of interconnects that won't shatter the bank....

....but I have some extenuating circumstances that may make that impossible. First things first, the interconnects both have to end in RCA Male-to-Male because I don't have an XLR option and every component uses RCA connections.

I am running a bi-wired and bi-amped system so the interconnect runs are rather long. The longest run is around 9 feet and connects my preamp to my Subwoofer In ( the Subwoofer is a Sunfire SDS-12 ). The second run is shorter but still long. It's the Subwoofer Out to the Amplifier In which is about 6 feet. Obviously, I am looking for interconnects that already have those RCA connections attached.

Any ( nice, polite and helpful ) suggestions?

j
stereoisomer
twoleftears's avatar
twoleftears
5,313 posts
 
Surprised that Audio Envy hasn't been thrown into the mix yet.
daledeee1's avatar
daledeee1
522 posts
 
Hi,

I have all Pine Tree Audio cables and IC.  Nice copper interconnects and ribbon speaker cables.  Customer service beyond expectations.  Quick shipment and reasonably priced.  I would say all the stuff I have is neutral in sound.  The IC  I have is 65 for 1M. 

PS  i think silver coated will give you a little brighter sound and will cost more.
curlyhifi
156 posts
 
I have been using Mogami Gold RCA too RCA.This cable can also be used as digital S/PDIF. I have tried many IC over the years and are very satisfied with MOGAMI XLR as well. Do your research and you will find that it is one of the cable choices for PRO. recording studios. 
elliottbnewcombjr
5,248 posts
 
using video cables for audio, a quickie find:

" ChrisWigglesWell-Known MemberLocation:Seattle
Okay, to answer your question correctly: YES. You absolutely may use video cables (75ohm coax) as an analog audio interconnect.

And in fact it is actually a good choice.

As HiFiGuy528 points out, you can also use a video coax as a digital audio interconnect (which requires 75ohm coax).

Curbach is correct that he does not know, and despite it 'sounding' like a bad idea, it is a perfectly fine idea, and you are most likely correct in assuming that these will probably better than some cheapos.

For analog audio, the primary needs are good shielding, and low capacitance. A video coax will by definition have a shield, and generally it should be quite decent, and often quite good particularly if it's a larger coax. In addition, a 75ohm coax, by the inherent physical geometry of a 75ohm coax line, will have rather low capacitance which is also good. Check and check!

It should also be noted that 75ohm CATV coax (the stiffer stuff for cable TV/Satellite, etc) is usually copper-clad-steel, and should NOT be used for any of these purposes (analog audio, digital audio, analog video, digital video). It should also be said that the reverse of your question (can I use an analog audio cable for video, digital audio, CATV?) will depend on the cable, but the answer may be NO (unless it is a 75ohm coax and it is so labeled clearly on the cable).

Cliff notes: absolutely go ahead and use them. And you should feel good about the choice. In fact, it's not a bad idea to buy high-quality video cables and use them everywhere as you are less likely to run into bizarre 'snake-oil' type designs. The disadvantages are (basically) nil, from an engineering perspective."
Post removed 
More to discover