Leaky capacitors need replacement?

@shawn3997

Just a FWIW, if those caps are used in an application where they are seeing a higher voltage closer to their rated voltage (in the photo it looks like its in a DC Blocker to me, but who knows), I can tell you from experience that those Illinois caps can do that well short of the time you expect of them. Switching to a Nichicon will assure longer life. As @clio09  recommends, replace them with the same value and voltage.

I will see if @clio09 has any of the original capacitors he can send me

Geez! why go that way, they look like old cheap stuff that may need to be formed, because they are so old, and the same thing may happen again.
Just get the better Nichicons I linked to for only a couple of bucks each.

Cheers George

I need to open the amp back up and take some pictures and measurements and I'll post them later.  It's just a matter of what will fit.

+1 georgehifi

OK, here's a bunch of pictures:
Imgur: The magic of the Internet

I have amp #1249, if that means anything regarding how old it is.

The caps needing replacement are around 15-20mm wide and 40-45mm or so long and are axial and connected as show in the pictures (picture #2, at the bottom right, the two grey ones). 

It looks like one side of each capacitor runs to the ground from the AC plug and then goes through the cap and a resistor to what I imagine is the transformer.  The two capacitors are connected together at ground and the two resistors are connected together at the transformer but they don't connect at the tabbed thingy in the middle, which is just a separator.

Can I shove some small radials in there?  Probably.  I have some vertical height to work with but will the leads be long enough to reach where they need to go?  I'm not sure.  That's my concern with radials.

I could also just use a couple of axials of approximately the same size.  I found two on Mouser:

336TTA350M Cornell Dubilier - CDE | Mouser
PEG124UH2330QL1 KEMET | Mouser

Here's detailed specs for the KEMET since no ripple current is listed:   PEG124UH2330QL1 (kemet.com)

It looks like either will fit fine.  Should I order some of these and take them and the amp to a local tech for replacement or are the radials mentioned preferred?