Do I expect too much?


Spent Sunday trying to track down an upper midrange rattle in my system - both channels but not necessarily exactly the same from side to side. I suspected loose or corroded connections but needed to move one of my Monitor Audio Gold 200 floorstanding speakers to access the back of my components. When I did I found a screw on the floor. The screw was only part of the footer and while it needed to be dealt with I don’t believe it was part of the issue. But that did get me to thinking about the speaker screws. These speakers have a unique driver mounting system where they are held in place by screws on the rear of the cabinet that physically pull the drivers into place. I checked them and on both speakers they were all significantly loose - one was about to fall out (my 19-year-old says it’s because I listen too loud but that is whole other string). 
So I looked in my MA manual and it didn’t even mention the screws. Next I went to the MA website and their contact us page allowed me to send an email to their North American distributor - Kevro. I asked for the torque spec. I did receive a prompt reply but was told, “there is no torque specification.  They should be tightened finger tight plus 1/4 turn. 
I expected more - am I wrong?  For one thing I am pretty sure my finger tight and oldhvymec’s finger tight are 2 very different things. For another these screws (maybe they are bolts - it’s a close call) have a broad flat head with a 4 mm hex inset - they aren’t really finger tightable (is that even a word?). 
Also any advice on how to proceed would be appreciated. I recall OHM saying he torqued the hell out of all his speaker screws (or some words to those effect). 
Thanks,

Matt
Ag insider logo xs@2xfeldmen4
I would only use the Loctite that is not permanent.  What if for some reason down the line you want to remove a driver?
Follow the manufacture/distributors recommendation.  Do not over-tighten.  I would not use any thread lock either.  Seriously, you’re trying to over-think a simple operation.  
Maybe think about replacing the existing screws with treadlocking ones, something like these would stand a better chance of staying put.
I am sorry it sounds like another case of we sell it do not know what to say when questioned about the product syndrome but i would say that you want the bolts more than finger tight in a speaker that produces vibration or you would be tightening all the time.
You can always add a Nylock nut to the existing nut, tightened to the same 1/4 turn.  Saves threadlocker (or drips), and isn't permanent.

And mind those bass line forays.... ;)

Nylock nuts ought to be a SOP for woofers, anyway....esp. sealed enclosures.