I have a kit from DB that is rca plugs with different loading values, I think up to 200 or 800 ohms, but it’s meant for MC carts, not MM.
Would these even be worth a try?
Would these even be worth a try?
Tweaking the new Grado Timbre Sonata 3
I have about 10 hours on my new Grado Sonata 3.
relevant system:
VPI Prime > Sonata 3> ARC PH3se (phono pre) > Herron 1A (preamp) > ARC Classic 60 (amp) > Thiel CS 2.4’s (speakers)
My old cart was a Nagaoka MP 500. While good, the Grado is better overall. But the highs are a bit more extended than the Nagaoka, which seems to be a bit excessive, but just a bit, almost, but not quite sibilant.
Alignment was done with my trusty AS Smartractor, though difficult to use on the Grado due to the long wood body overhang on the Grado.
Raising and lowering VTA has little effect.
My question, before I get too worried about this prior to complete break in, is will the highs “soften” up once broke in. Is that typical with Grados? Or, is it I gots what I got.
relevant system:
VPI Prime > Sonata 3> ARC PH3se (phono pre) > Herron 1A (preamp) > ARC Classic 60 (amp) > Thiel CS 2.4’s (speakers)
My old cart was a Nagaoka MP 500. While good, the Grado is better overall. But the highs are a bit more extended than the Nagaoka, which seems to be a bit excessive, but just a bit, almost, but not quite sibilant.
Alignment was done with my trusty AS Smartractor, though difficult to use on the Grado due to the long wood body overhang on the Grado.
Raising and lowering VTA has little effect.
My question, before I get too worried about this prior to complete break in, is will the highs “soften” up once broke in. Is that typical with Grados? Or, is it I gots what I got.
- ...
- 20 posts total
- 20 posts total