2. cables
  3. 1262108512

Dedicated lines- need break in?

Surely a, stupid question of the day!
Finally had 2X 20 amp dedicated lines installed with Oyaide outlets with isolated grounds. Hooked up sources and preamp to the lines to start with......, and sound is much clearer and as a result slightly on thinner side (in comparison, although still anything but analytical). I know it is not Oyaide outlets because I had them connected on regular lines and they sounded warmer. (I have electrician coming back today to try out different phase than the refrigerator, ac, microwave etc. to check if the current in phase circuit breaker is not causing the change in sound)

So the question is, in your experience, the new 20 amp lines need to be broken in? How long does it need to be? or what could be the cause?

Thanks,

Nil
nilthepill
rwwear
2,848 posts
 
Be careful running heaters on long extension cords unless they are very heavy duty. A friend burned down his recording studio by leaving a heater running overnight on a lightweight extension cord. It was under a rug which caught fire.
nilthepill OP
842 posts
 
Thanks for the tip, Rwwear. Yes, I am using heavy duty cords (Orange) and turn them off during night and when no one is around. It might take a bit longer but a lot safer.
cesoj
10 posts
 
Sine waves in your ac lines are all going to the panel via wires which motors and ballast from lights and harmonics from unfiltered computers will cause the most potential problems. The best thing you can do is to balance the loads at the panel and keep your sensitive electronics isolated on separate circuits if possible. If I was to do it right I would have all my audio and video gear fed from a powerwall after the panel. It is basically a large house battery than is more stable than your local power company.
michaelgreenaudio's avatar
michaelgreenaudio
1,019 posts
 
All audio systems are continuum, just like all interactive forces. They never stop breaking in.
Post removed 
More to discover